Mark Stodola wrote:
Michael,
Odds are mkfs was run on sdc and not sdc1 initially. Your plan is good,
backup the data and reconfigure the filesystem as you want, then restore
the data. There aren't really any tricks to shuffling the data with dd.
except the need to ensure target is big enough to receive data. I would
probably use another disk so as to ensure I didn't stuff it up.
I'd also consider dump/restore even though I've never used them. If you
use dd, you need to fsck and resize before copying if the target's
smaller, fsck and resize after if it's larger, and the odds of source
and target being the same size are not good, unless you decide not to
partition the target drive at all.
If you use dd, you will have this apparent partition table after the
event. I don't think it would cause problems, though you can never be sure.
Cheers,
Mark
Michael Hannon wrote:
Greetings. This is slightly off-topic, but I hope it's of sufficient
interest to warrant posting here.
We've got a computer here that's running Fedora 8, i386. The machine
has two external drives, both mounted to an eSATA controller (Silicon
Image, Inc. SiI 3114 SATARaid Controller).
The disks are 750GB and 500GB, respectively, in size.
Everything seems to work as expected, except that the 750GB drive is
somehow getting mounted on the device, rather than on a partition:
/dev/sdc 688G 554G 100G 85% /local3
There IS a partition on the drive:
# fdisk -l /dev/sdc
Disk /dev/sdc: 750.1 GB, 750156374016 bytes
255 heads, 63 sectors/track, 91201 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0x3e863a4f
Device Boot Start End Blocks Id System
/dev/sdc1 1 91201 732572001 83 Linux
But my attempt to mount the drive on sdc1 results in:
# mount -t ext3 /dev/sdc1 /local3
mount: wrong fs type, bad option, bad superblock on /dev/sdc1,
missing codepage or helper program, or other error
In some cases useful info is found in syslog - try
dmesg | tail or so
I don't really understand what's going on here or how the system got
into this peculiar configuration.
I'm inclined to back up the data from the mounted /local3, then
re-create the partition, then re-initialize the file system on sdc1,
then restore the data.
But I was wondering if there might be some way to short-circuit that
process, maybe by using dd to copy some information from /dev/sdc to
/dev/sdc1. Is this possible? If so, is it risky? Is there a better
approach?
Thanks.
-- Mike
--
Cheers
John
-- spambait
[EMAIL PROTECTED] [EMAIL PROTECTED]
-- Advice
http://webfoot.com/advice/email.top.php
http://www.catb.org/~esr/faqs/smart-questions.html
http://support.microsoft.com/kb/555375
You cannot reply off-list:-)
