I don't do a lot of work with serial ports and I know this should be an obvious
question. I've several linux boxes running SL4.7 or 5.0.
I have a digitizer connecting to a serial port via RS232 cable with trivial
settings (start bits 1, data bits 8, parity none, stop bit 1 with a variety of
baud rates supported - which works with windows hyperterminal.
I know that /dev/ttyS files are the serial device files. I can cat
/proc/interrupts to see the serial IRQ that is active (4):
4: 43043 40334 IO-APIC-edge serial
I can do sudo setserial -bg /dev/ttyS* to see which are available:
/dev/ttyS0 at 0x03f8 (irq = 4) is a 16550A
or do
sudo setserial -g /dev/ttyS[0-9]
/dev/ttyS0, UART: 16550A, Port: 0x03f8, IRQ: 4
/dev/ttyS1, UART: unknown, Port: 0x02f8, IRQ: 3
/dev/ttyS2, UART: unknown, Port: 0x03e8, IRQ: 4
/dev/ttyS3, UART: unknown, Port: 0x02e8, IRQ: 3
/dev/ttyS4, UART: unknown, Port: 0x0000, IRQ: 0
...(same)
At this point, I'm not sure of a few things. This is linux SL4.7 PC with a
PS/2 mouse.
1) When I connect cable to 9-pin serial port, which device is associated with
it?
2) stty presumably allows me to configure the serial port to my liking, but
which ones do I want for my trivial usage?
I'm thinking...
stty -F /dev/ttyS2
-parenb (disable parity generation and detection)? I've got no parity?
cs8 - this is character size, so this is 8 data bits?
-cstopb - use one stop bit per character (stop bits: 1)
19200 - desired baud rate
Not sure about start bit = 1 setting or if above is appropriate, so many
parameters with stty.
So, stty -F /dev/ttyS2 -parenb cs8 -cstopb 19200
and then the ttyS2 file is available for use, if ttyS2 was associated with my
serial port connection.
Then, a c program could open and work with this
fd = open("/dev/ttyS2",O_RDWR | O_NDELAY | O_SYNCIO)
or matlab could open the serial port? Currently matlab tells me no ports are
available.
s2 = serial('/dev/ttyS2');
get(s2);
fopen(s2);
Bill Lutter
