On 07/02/2014 11:40 AM, Andras Horvath wrote:
Good thinking would be, but as I mentioned before, I tested this issue on
several hardware. With 2 new disks, new enclosures (3 kinds but same type), on
different kind of servers and with different USB cables.
That does seem to cover it quite well; while it is a bit of a long shot
it is possible all three enclosures used the same USB to SATA bridge.
The odd part is that if it were intrinsic to the kernel or the USB stack
of the OS one would think other people would have seen the problem (and
thus why you asked the list if anyone else had seen the problem....:-)).
I think it must be the software causing this. Especially because the same
hardware setup worked fine for long on Debian 6. That's why I turned to the SL
mailing list.
And that's the correct course.
So disk is ok, cable end enclosure is ok, and server hw must be too I believe.
I would tend to agree. But there has to be something different here,
otherwise I would think the list would be inundated with similar
reports. I can't directly test SL 6 in this case, since I don't have an
active SL 6 box at the moment, but my CentOS 6.5 laptop and a couple of
CentOS 6 servers (Dell PowerEdge 1950) we have here do large USB data
transfers frequently without seeing your issue. It is possible the SL
kernel and USB stack have some differences to the CentOS kernel and USB
stack, even being built from the same sources; I would not think that
likely, and I would think that CentOS 6 in your circumstance should
produce the same results.
In order to actually replicate the results we would need detailed
information on the exact hardware that has been used that exhibits the
problem (even down to the firmware rev of the WD hard disk), and then
someone with that same hardware would need to replicate. It could be
difficult.
But if you're satisfied with the SATA connection, just use it. I for
one would like to find out what's actually going on, and help figure out
how to actually fix it.
