Hi, I am having problems setting up a solwise SAR110 adsl router with a no-nat configuration and wonder if anyone here has set up an adsl router with a similar config. I simply want to connect the router to our smoothwall and have been allocated an address range of 4 ip addresses. The problem seems to be with the default route not going through the ppp interface.
Our ISP said they cannot help, despite having tutorials for no-nat setups for two other types of modems but not this supplied one. I was able to set up the router with the standard nat option ok, but according to the ISP, to set it up as no-nat, all I need to do is configure eth-0 with appropriate ip address/mask from range supplied. To test this, I have set up a laptop with the other useable ip address/mask and the laptop and router can talk to one another. The router gets authenticated and connected to the ISP network (As confirmed by support) and sets up some dynamic routes. I have tried configuring the router by leaving the ip address of the ppp interface blank, which automatically gets allocated the correct ip address on connection and also set the ip address manually on the ppp interface. This is the routing table with a no-nat config where: address range: 212.159.29.4/30 dns: 212.159.11.150, 212.159.13.150 --------------------------------------------------------------------------- Destination netmask next hop ifname type 0.0.0.0 0.0.0.0 195.166.128.11 eth-0 indirect 127.0.0.0 255.0.0.0 127.0.0.1 lo-0 direct 195.166.128.11 255.255.255.255 212.159.29.5 eth-0 indirect 212.159.11.150 255.255.255.255 195.166.128.11 eth-0 indirect 212.159.13.159 255.255.255.255 195.166.128.11 eth-0 indirect 212.159.29.4 255.255.255.252 212.159.29.5 eth-0 direct 212.159.29.5 255.255.255.255 127.0.0.1 lo-o direct the routing table with the nat config is similar but the default route is via ppp-0 0.0.0.0 0.0.0.0 195.166.128.11 ppp-0 indirect 195.166.128.11 255.255.255.255 212.159.29.5 ppp-0 direct The configuration (web and CLI) does not allow me to specify the interface when adding or modifying routes. Support also gave me instructions on adding a BIMAP nat rule which does not work either. Any help would be appreciated. _______________________________________________ Scottish mailing list [EMAIL PROTECTED] http://mailman.lug.org.uk/mailman/listinfo/scottish
