On 02/05/2018 09:51 AM, Mark Cornwell wrote: > Hello, > > > > I'm new to Scribus. I've been designing a layout for a photo book with text. > > > > I've put in lots of pages and images/text etc. Then I went to create a TOC. > > > > I also spotted the Ctrl+Alt+Shift+P to add a page number to a page and to > add a text box with that in it on the master. > > I also found out how to set up page numbering to start after the TOC via > Document Setup>Sections. > > > > So far so good. > > > > My document now has three pages with no page numbering (intro/TOC) and then > starts with page number 1 on page layout 4. > > > > That's all working. > > > > What I can't work out is that when I get to page 10 the page numbers just go > blank again. > > > > My sections have: > > Name 0, Shown tick, From 1, To 3, Style None, Start 1. > > Name 1, Shown tick, From 4, To 57, Style 1,2,3., Start 1. > > > > I've not "stopped" the section at page 10. > > > > I have tried applying the master again to all pages. That didn't make any > difference. All I see on pages 10 and beyond in Scribus is a rectangle with > a small box with a cross in it to the bottom right. If I create a PDF via > Export then it leaves the page numbers empty on pages 10 and beyond. > > > > Just in case it is relevant - pages 34 and onwards are currently blank. > > > > Any bright ideas, please? >
Have you checked to make sure you have applied the master page to 10 and beyond? Greg
