> To keep your CPU safe I would recommend to replace those 10 ohm
> resistors with something larger (470 ohm or more)...
> Furthermore to test your setup try writing all '1's to the output ports
> and check if all leds light up, or take a voltmeter and check the ouptut
> pins. Maybe all LEDS are mounted the wrong way around ? (The longer pin
> is usually the positive or anode but some manufacturers mix them up)
>
> Regards,
>
> Gert
i think the LED connection is correct. i did try to put a power directly to
the LED
and the LED light up. I will increase the resistor value. I begin to wonder
about the
MCLR connection at PIN one. Does it have any effect on my circuit? Currently
i simply connect
the PIN 1 (MCLR) to Vdd. Is it the correct way?
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Sdcc-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/sdcc-user
