* lautriv <[email protected]> [121121 13:35]: > Hello, > i tried to get seabios up via payload from coreboot and failed on > the initialisation > of neccessary devices. > The board in Question is a Tyan S4882, consisting of K8 northbridge, > 8131 southbridge, 8111 southbridge and Winbond w83627hf SuperIO. > You will see on the following pastebin-url that coreboot does a > proper init and can see all relevant devices. > I was also able to get VGA up via coreboot ( to reflect an > accessible device below root ) but not from within seabios. It > probes only against PCI 00:18.0 ... 00:18.3 which are on the > northbridge itself. > I had a look on the sources and found it should see and init the > whole tree, also checked my sources against some patches i found on > the net and they are all applied or superseded.
I think you need to change the board's HT configuration so that the southbridge ends up on bus 0 instead of 1 (with no pci bridge pointing to bus 1) Stefan _______________________________________________ SeaBIOS mailing list [email protected] http://www.seabios.org/mailman/listinfo/seabios
