On Sat, Dec 28, 2013 at 07:40:01PM +0100, Gelip wrote: > I did a log but I think that there is nothing interesting to put the full > log. I put the same end of the log boot from a floppy image and floppy disk. > > Succesful qemu boot from BOOT-PROM3 floppy image: > ================================================= > Booting from Floppy... > Floppy_drive_recal 0 > Floppy_enable_controller > i8042_command cmd=ae > i8042_wait_write > Floppy_media_sense on drive 0 found rate 0 > Booting from 0000:7c00 > Floppy_disable_controller > Floppy_enable_controller > Floppy_drive_recal 0 > Floppy_media_sense on drive 0 found rate 0 > i8042_command cmd=ae > i8042_wait_write > i8042_command cmd=ae > i8042_wait_write > Floppy_disable_controller > Floppy_enable_controller > Floppy_drive_recal 0 > Floppy_media_sense on drive 0 found rate 0 > ================================================= > > Unsuccesful boot Abit BF6 from BOOT-PROM3 floppy disk: > ========================================================================= > Booting from Floppy... > Floppy_drive_recal 0 > Floppy_enable_controller > Floppy_media_sense on drive 0 found rate 0 > Booting from 0000:7c00 > Floppy_disable_controller > Floppy_enable_controller > Floppy_drive_recal 0 > Floppy_media_sense on drive 0 found rate 0 > i8042_command cmd=ae > i8042_wait_write > i8042_command cmd=ae > i8042_wait_write > floppy error: 44 20 20 1c 01 0a 02 > invalid basic_access:96: > a=00000200 b=00000000 c=00001c0a d=00000100 ds=5000 es=6360 ss=df80 > si=00000000 di=000057c0 bp=0000001e sp=0000fd20 cs=5000 ip=0188 f=0246 > =========================================================================
Interesting. Can you set the seabios debug level to 3, and set DEBUG_HDL_13 to 1 in src/config.h and then post both the qemu and coreboot logs again? This still seams like a seabios thing to me. -Kevin _______________________________________________ SeaBIOS mailing list [email protected] http://www.seabios.org/mailman/listinfo/seabios
