Re: [SeaBIOS] Does SeaBIOS support eMMC?

[Kevin O'Connor]

On Tue, Jan 12, 2016 at 05:07:08PM +0000, Scheithauer, Mario wrote:
> > -----Ursprüngliche Nachricht-----
> > Von: Kevin O'Connor [mailto:ke...@koconnor.net]
> > Gesendet: Dienstag, 12. Januar 2016 17:15
> > An: Scheithauer, Mario
> > Cc: seabios@seabios.org
> > Betreff: Re: [SeaBIOS] Does SeaBIOS support eMMC?
> > 
> > On Mon, Jan 11, 2016 at 03:49:19PM +0000, Scheithauer, Mario wrote:
> > > First I will clone a new coreboot with an actual SeaBIOS. After that I
> > > will give you a new log.
> > > But second I think sdcard setup is not ready for JEDEC Standard
> > > 84-B51. Maybe I'm wrong with that.
> > 
> > I did use that JEDEC standard as a reference when writing the code.
> > 
> > > Our eMMC flash has a size of 8GB but recognized are only 2GB and I
> > > believe for switching to high-speed mode there are some more steps
> > > necessary.
> > 
> > SeaBIOS does not attempt to enable high speed mode or to enable multiple 
> > read
> > data lines.  The goal is just to boot the OS - the OS can then enable 
> > whatever
> > optimizations it wants.
> 
> Well, I understand.
> 
> > The drive is showing up as an 2TB drive, so something is clearly wrong with 
> > the
> > size detection.  Upon attempting to boot from the drive, a read CRC error 
> > occurs.
> > I wonder if the drive is not in sync with the controller on the number of 
> > data lines in
> > use.
>  
> I believe the mechanism to determine the size for eMMC4.5 devices are 
> differently than up to now.
> However, that is no problem.

Yes - on v4.0 and later MMC devices SeaBIOS reads from the size from
the EXT_CSD register.  The log indicates that SEND_EXT_CSD was sent,
so SeaBIOS is recognizing the hardware version, and the command
completes without error.  But the size results do look suspect.

I double checked, and other users are reporting success on SeaBIOS
with v4+ eMMC devices.

> > How many SD/MMC devices are in this machine?  In addition to the eMMC drive
> > that is detected, another device starts the detection on a different 
> > controller but
> > fails earlier in the process.  Is that expected?
> 
> We have two Storage Control Cluster, one for SDIO / SD and one for eMMC 4.5.
> In my opinion a device should be only at the second SCC connected.
> However, should the last version of Lubuntu not work with that?
> Lubuntu detects an mmc block device (mmcblk0boot0 and mmcblk0boot1).
> But the size is not correct. Both blocks have a size of 256kB.
> Fdisk cannot install a partition and ends with the error message 'failed to 
> write disklabel: Operation not permitted'.
> Maybe we have a hardware issue, because the eMMC device is directly on the 
> board.

To verify if Linux can use the device, I suggest disabling
CONFIG_SDCARD in SeaBIOS, hard poweroff the machine for a minute (and
pull the battery if it is a laptop), and then boot Linux from another
media.  Linux should be able to detect/read/write the device.  We've
seen that some eMMC devices can get stuck in a bad mode, so a full
power off may be needed.

If Linux can't detect/read/write the device, then I suggest addressing
that before looking at the SeaBIOS code.

Otherwise, can you try the SeaBIOS patch below and report the
additional debugging?

-Kevin


--- a/src/hw/sdcard.c
+++ b/src/hw/sdcard.c
@@ -490,6 +490,8 @@ sdcard_controller_setup(struct sdhci_s *regs, int prio)
             , readw(&regs->controller_version)
             , readl(&regs->cap_lo), readl(&regs->cap_hi));
     sdcard_reset(regs, SRF_ALL);
+    dprintf(1, "hc1=%x hc2=%x\n"
+            , readb(&regs->host_control), readw(&regs->host_control2));
     writew(&regs->irq_signal, 0);
     writew(&regs->irq_enable, 0x01ff);
     writew(&regs->irq_status, readw(&regs->irq_status));
@@ -515,6 +517,8 @@ sdcard_controller_setup(struct sdhci_s *regs, int prio)
         free(drive);
         goto fail;
     }
+    dprintf(1, "later hc1=%x hc2=%x\n"
+            , readb(&regs->host_control), readw(&regs->host_control2));
     return;
 fail:
     writeb(&regs->power_control, 0);

_______________________________________________
SeaBIOS mailing list
SeaBIOS@seabios.org
http://www.seabios.org/mailman/listinfo/seabios