Hello,
I'm not sure if this is the right forum for a technical question such as this,
so my apologies if this is inappropriate.
We recently acquired Kasli (v. 1.1.) board with Urukul DDS addon, and now we've
had some elementary problems when in the installation.
So I've been following the 4.0.dev-branch documentation for installation.
While installing artiq packages using conda, I assumed we had opticlock-variant
of kasli (so I figured out from the documentation).
I was able to flash FPGA gateware bitstream by doing:
$ artiq_flash -t kasli
Following this I set IP and MAC addresses:
$ artiq_mkfs flash_storage.img -s mac 75:53:7b:9c:63:14 -s ip 192.168.1.10
$ artiq_flash -t kasli -f flash_storage.img storage start
Now I tried to write the core kernel to the board by (after successful
compilation of idle_kernel)
$ artiq_coremgmt config -f idle_kernel idle_kernel.elf
This gives an error about having no route to host. So I can't establish a
network connection to the board.
Here I prepared device_db.py, with core_addr = "192.168.1.10". Is this correct
way to set the target IP address? Configurations are done on a computer with IP
set to 192.168.1.1, netmask set to 255.255.255.0 and connected to the Kasli
board through a gigabit switch with SFP ports. On Kasli, I'm using SFP0 port
for the fiber.
Any ideas? am I doing something wrong?
BR
Kalle Hanhijärvi
___
ARTIQ mailing list
https://ssl.serverraum.org/lists/listinfo/artiq
