Good morning all,
I had this problem show up this morning and haven't figured out what has
changed.
I use a MicroKeyer II (MKII) with the K3.
After working some FT8 DX this morning I went to calling CQ and I noticed
that I wasn't getting any RF output.
The first thing I looked at was the line setting figuring it got bumped and
I just needed to adjust. That wasn't the case. I can't get any RF out
regardless of the setting.
Here's the setup on the K3:
DATA A
Mic Sel: Line In
Mic Setting: varied from 0 to 60 with no effect.
I've tested the setting from within WSJT and everything seem fine.
I have power cycled the MKII, the K3, reinstalled the WSJT-X software
(v1.9.1). I do use a DXLab "bridge" to DXkeeper but that seem to be working
fine.
The K3 goes into TX mode but there is no RF according to the watt meter.
I've tried FT8 on other bands and the same problem. Everything looks right
except there is no RF out. Any suggestions on what to try will be greatly
appreciated.
Glenn
N5RN
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com