[Elecraft] Fixed: K1 AF sidetone loudness proble
Hello, i got it fixed. The fix was described earlier in this thread - replacement of Q10 (2N7000 Mosfet) and Q11 (J309 JFET) on the RF Board did it for me. By the way: The J309 seems to be discontinued.. Thanks all Roland, DF1OE -- View this message in context: http://elecraft.365791.n2.nabble.com/K1-AF-sidetone-loudness-problem-tp7596933p7597196.html Sent from the Elecraft mailing list archive at Nabble.com. __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
Re: [Elecraft] K1 AF sidetone loudness problem ?
Hi Don, thanks for Your reply - midwhile i found an other suggestion too in the mailing-list. Q10 and Q11 j309 and 2n7000 where changed and the click went away. .so i have a lot of possibilitys to work on hi. I will keep you informest. The k1 4 band is a vy nice radio - i wish the kx3 has ist form factor (but i know it is only possible by shrinking our fingertips. Roland, DF1OE, www.df1oe.de http://www.df1oe.de , df...@qrz.com mailto:df...@qrz.com , www.baerenfunk.com http://www.baerenfunk.com Von: Don Wilhelm-4 [via Elecraft] [mailto:ml-node+s365791n7596999...@n2.nabble.com] Gesendet: Montag, 12. Januar 2015 03:01 An: Roland_DF1OE Betreff: Re: K1 AF sidetone loudness problem ? Roland, Your suspicion about the T/R switch *may* be correct, but before you make any changes, check the menu for the T-R setting. The default is 50 ms. If you are using a small value, the receiver may be unmuting quickly enough that you actually hear a bit of the residual RF. I was not able to view your video - OneDrive just keeps 'spinning its wheels' as if it is loading, but I waited for over 5 minutes (two times) and it still did not load. 73, Don W3FPR On 1/11/2015 12:11 PM, Roland_DF1OE wrote: Hi Don, finally i did the reset of the radio and all the alignment procedures again. I managed to get the loudness of the sidetone ok (but i am still thinking one oft he T/ R diodes openes slowly ), but as a result now i have a strong burst at every tone (only if hf is on). Even if the sidetone is off and hf is produced the burst is heard - it grows loude with the af gain, so it is produced before the AF amplifier - hope so. __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [hidden email] _ If you reply to this email, your message will be added to the discussion below: http://elecraft.365791.n2.nabble.com/K1-AF-sidetone-loudness-problem-tp75969 33p7596999.html To unsubscribe from K1 AF sidetone loudness problem ?, click here http://elecraft.365791.n2.nabble.com/template/NamlServlet.jtp?macro=unsubsc ribe_by_codenode=7596933code=ZGYxb2VAbGl2ZS5kZXw3NTk2OTMzfDEwNDI5OTM1ODg= . http://elecraft.365791.n2.nabble.com/template/NamlServlet.jtp?macro=macro_v iewerid=instant_html%21nabble%3Aemail.namlbase=nabble.naml.namespaces.Basi cNamespace-nabble.view.web.template.NabbleNamespace-nabble.view.web.template .NodeNamespacebreadcrumbs=notify_subscribers%21nabble%3Aemail.naml-instant_ emails%21nabble%3Aemail.naml-send_instant_email%21nabble%3Aemail.naml NAML -- View this message in context: http://elecraft.365791.n2.nabble.com/K1-AF-sidetone-loudness-problem-tp7596933p7597068.html Sent from the Elecraft mailing list archive at Nabble.com. __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
Re: [Elecraft] K1 AF sidetone loudness problem ?
Hi Don, finally i did the reset of the radio and all the alignment procedures again. I managed to get the loudness of the sidetone ok (but i am still thinking one oft he T/ R diodes openes slowly ), but as a result now i have a strong burst at every tone (only if hf is on). Even if the sidetone is off and hf is produced the burst is heard - it grows loude with the af gain, so it is produced before the AF amplifier - hope so. You can see/hear it in this little video: https://onedrive.live.com/redir?resid=FBF8BAC7649FCD9B!856 https://onedrive.live.com/redir?resid=FBF8BAC7649FCD9B!856authkey=!AJAxQrX x4ZPblzAithint=video%2cMOV authkey=!AJAxQrXx4ZPblzAithint=video%2cMOV The burst is vy loud and a pain even in the headphones - so i keep on searching. and will look on the frontpanel U2 and so on. Vy 73 Roland, DF1OE Von: Don Wilhelm-4 [via Elecraft] [mailto:ml-node+s365791n7596958...@n2.nabble.com] Gesendet: Samstag, 10. Januar 2015 04:08 An: Roland_DF1OE Betreff: Re: K1 AF sidetone loudness problem ? Roland, I have never seen that kind of problem. It does sound like something may be corrupt in the EEPROM. You may want to try resetting the K1 to factory defaults (which wipes out your menu settings and replaces them with the stock factory defaults). Before you do that reset, record all your menu settings so you can restore them - but some such as the CAL OPF values will have to be done from scratch. Do know that the sidetone level on the K1 does vary with the setting of the AF Gain control, so if you are change the AF Gain during transmission, the sidetone level may increase/decrease with the AF gain. Still, a loud sidetone with SL L set to 1 should be very quiet. If the reset does not correct it, I would first replace Front Panel U2, next FP U1, and last FP U3. 73, Don W3FPR On 1/9/2015 9:57 AM, Roland_DF1OE wrote: Last Year i built my k1 #3310 - i got one of the last 4-Band filter boards. With the k1 i had some fun as TF/DF1OE/p last year in iceland... Just built the k1 for this adventure with a tent and backpack. I ve a little problem - may be it is quite normal, i do not know. during sending cw the sidetone is very very loud - louder as it is during adjusting ST_L and much louder than testing it with no cw HF transmission. During transmission it gets louder after a time. Even if i put ST_L to 1 (one) i get a loud sidetone during cw hf transmission. Any hints are appreciated. Roland, df1oe [hidden email] -- View this message in context: http://elecraft.365791.n2.nabble.com/K1-AF-sidetone-loudness-problem-tp75969 33.html Sent from the Elecraft mailing list archive at Nabble.com. __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [hidden email] __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [hidden email] _ If you reply to this email, your message will be added to the discussion below: http://elecraft.365791.n2.nabble.com/K1-AF-sidetone-loudness-problem-tp75969 33p7596958.html To unsubscribe from K1 AF sidetone loudness problem ?, click here http://elecraft.365791.n2.nabble.com/template/NamlServlet.jtp?macro=unsubsc ribe_by_codenode=7596933code=ZGYxb2VAbGl2ZS5kZXw3NTk2OTMzfDEwNDI5OTM1ODg= . http://elecraft.365791.n2.nabble.com/template/NamlServlet.jtp?macro=macro_v iewerid=instant_html%21nabble%3Aemail.namlbase=nabble.naml.namespaces.Basi cNamespace-nabble.view.web.template.NabbleNamespace-nabble.view.web.template .NodeNamespacebreadcrumbs=notify_subscribers%21nabble%3Aemail.naml-instant_ emails%21nabble%3Aemail.naml-send_instant_email%21nabble%3Aemail.naml NAML -- View this message in context: http://elecraft.365791.n2.nabble.com/K1-AF-sidetone-loudness-problem-tp7596933p7596979.html Sent from the Elecraft mailing list archive at Nabble.com. __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
Re: [Elecraft] K1 AF sidetone loudness problem ?
Hi Don, i did all the steps Mike suggested to me - some more e.g. resoldering some suspicious pads. The K1 is still in the workbench. I will start building the internal atu, but will first fix this issue. Before resetting the radio i will put a small audio/video file on the internet, and give you both a note for examining it. 72, 73 Roland, DF1OE -- View this message in context: http://elecraft.365791.n2.nabble.com/K1-AF-sidetone-loudness-problem-tp7596933p7596960.html Sent from the Elecraft mailing list archive at Nabble.com. __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
[Elecraft] K1 AF sidetone loudness problem ?
Last Year i built my k1 #3310 - i got one of the last 4-Band filter boards. With the k1 i had some fun as TF/DF1OE/p last year in iceland... Just built the k1 for this adventure with a tent and backpack. I ve a little problem - may be it is quite normal, i do not know. during sending cw the sidetone is very very loud - louder as it is during adjusting ST_L and much louder than testing it with no cw HF transmission. During transmission it gets louder after a time. Even if i put ST_L to 1 (one) i get a loud sidetone during cw hf transmission. Any hints are appreciated. Roland, df1oe df...@live.de -- View this message in context: http://elecraft.365791.n2.nabble.com/K1-AF-sidetone-loudness-problem-tp7596933.html Sent from the Elecraft mailing list archive at Nabble.com. __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com