Phil,
Adjust CAL S LO first, then adjust CAL S HI. There may be some
interaction, so if you do find some, do the sequence over again until it
is correct.
73,
Don W3FPR
Phillip Heller wrote:
> Hi there,
>
>So, I've made it through Alignment/Test 2. All numbers right down
> the middle, save the AGC threshold voltage, which was solved by adding
> 10k across Control RP6 pins 3&4.
>
> So, I complete the S-Meter alignment per Alignment/Test 1. No problem.
>
> Then, after I finished Alignment/Test 2, I figured I'd attach the XG2
> to get a little bit more accurate.
>
> So I attach, follow the directions to a T, tune to 7040.30 (where I
> find the 40m signal to be loudest) and adjust S-Hi to show S9 for 50mv
> output. Well, I can't get it to land right on 9, but 9 +/- 1 bar.
>
> However, per the directions, I'm told that once I turn the XG2 off,
> the S-Meter should drop to 0 or 1 bars. However, it stays the same.
>
> Any thoughts?
>
> Regards,
>
>Phil
>
>
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
