Frank,
The problem has to do with the light conductivity of the LCD diffuser.
It is possible that one of the thin plastic sheets on the diffuser that
should not have been removed was actually removed during assembly.
The only correction is to replace the diffuser. Unfortunately, it is
below the LCD and inside its pins. While removing the LCD with its many
pins may be possible, it is not practical. If you want to change the
diffuser, you will have to remove the LCD. The best (safest) method is
to cut the LCD pins near the LCD body and remove the pins one at a
time. Then remove the diffuser.
Replace both the diffuser and the LCD.
If that is too much pain, you will have to live with it as-is.
73,
Don W3FPR
On 3/30/2015 12:05 PM, Frank Krozel wrote:
Folks, I have two of these one is S/N 906 and the other one is 57xx.
The light on 906 is bright on both ends and the 57xx is about the same level
across the display.
Without tearing apart both… anyone know what I can change on 906 to make it the
same level of brightness across the panel?
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com