Bonsoir à tous,
Est ce qu'une bonne âme pourrait me traduire un bout de la notice de se
contrôleur, perso. je n'ai pas réussi à comprendre
l'astuce, du coup j'ai mis un autre contrôleur, qui lui n'a rien comme
réglages!!!!.... mais comme c'est pour un Electro7 avec un moteur
Scorpion, j'aimerai bien utiliser le YEP qui permet d'optimiser les
réglages.
La partie qui m'intéresse est celle-ci (pas besoin de me traduire les
termes "brake" "battery typ" "timing" "PWM-Frequency" et "Governor mode"
Advanced-Setup:
For the Advanced Setup, the Basic Setup must have been performed at
least once!
1. Make sure that the ESC is off; switch on the transmitter with the
throttle stick at full power.
2. Hold the Model, Connect the ESC with motor and battery => a
monotonous continuous beep should be heard.
3. *????????*....: after approximately 20 tones, the advanced setup is
activated as long as the basic setup has been performed!
Programmation avancé:
Pourune programmationavancée,la programmationde basedoitavoir été
exécutéeau moinsune fois!
1. Assurez-vousque le contrôleur n'est pas branché,
allumerl'émetteuraveclemanche des gaz sur "plein gaz".
2. Tenezlemodèle,reliezle contrôleur à la batterie, unsignal
sonorecontinudevraitêtre entendu.
3. ????????....: aprèsapproximativement20bips,la programmationavancéeest
faite *(je pense que cette manip a pour but de calibrer la course des gaz)*
Acknowledgement ¶¶ => Advanced Setup
If the continuous beeps are not heard, please disconnect immediately the
battery from the ESC and operate everything again. Place the transmitter
in a good range of the receiver if the antenna is not extended.
In the advanced setup only ONE Menu option can be selected, therefore
the main menu choice must take place first:
Place the stick again into full back position to select the main meun to
modify:
Main Menu Options overview: (j'ai bien tenté de traduire la partie
ci-dessus mais ça reste indéchiffrable pour moi!!!...)
? Brake
?? Battery-Typ
? ? ? Timing
? ? ? ? PWM-Frequency
? ? ? ? ? Governor mode
Move the stick to full power after hearing the sounds for the desired
parameter.
Acknowledgement: *? ?*
*Note: *If any parameter has not be selected, the menu will begin again
with "Brake" and so on; If
selected, depending upon the selection now the ESC switches to the
setting of the Parameter.
Possible (sub) menus:
1 Brake (*?*)
Brake selection
(Brake): Move stick into full back position again
*? *No Brake
*?? *Brake, Brakeis activated if stick range has been configured
accordingly.
Move the stick to full power to select the desired setting in the
submenu. Acknowledgement: ? ?
After the acknowledgement the menu option is programmed!
If the stick is took back to full back position, the ESC is armed and
ready for working after the ready signal sounds was heard. This applies
to each programming step.
If no selection is made, the above selection menus start over again
until a selection is made.
Battery-Typ(??)
Battery selection (Battery-Type):
Move stick into full back position again:
*? *NiMh
*?? *Auto
*? ? ? *Reserved
D'avance merci.
Jean