RE: Setting a value on a emiter

2012-10-12 Thread Pierre Rousseau 
Hi Ben, there is different ways of doing this. 
 
- You can either use 2 emitter nodes and for each one set different State 
Values,
 
- Paint weight maps of differents values on each emitter and use Get Weight Map 
Value to filter your particles
 
- Or if your emitters aren't moving too much, set a volume around one emitter 
and at birth, if the particle is inside it, set it's value to one instead of 
zero.
 
Pierre Rousseau
Vision Globale
514-848-6159 Poste 2525
Département Scrap and Magic
 



From: Ben Beckett [mailto:nebbeck...@gmail.com] 
Sent: October-12-12 11:40 AM
To: softimage@listproc.autodesk.com
Subject: Setting a value on a emiter


Hi List 

I was wondering if I had two emitters, and I wanted to give the particles 
coming out of emitter 1  a value  of 1 and particles coming out of emitter 2 a 
value 2.

Or in another terms, emitter 1 would all have a ID of 1 and emitter 2 would all 
have a ID of 2 so later I could filter and make them do something different.

Any help would be brill
Thanks
Ben

Setting a value on a emiter

2012-10-12 Thread Ben Beckett 
Hi List

I was wondering if I had two emitters, and I wanted to give the particles
coming out of emitter 1  a value  of 1 and particles coming out of emitter
2 a value 2.

Or in another terms, emitter 1 would all have a ID of 1 and emitter 2 would
all have a ID of 2 so later I could filter and make them do something
different.

Any help would be brill
Thanks
Ben