-Original Message-
From: [EMAIL PROTECTED] [mailto:asterisk-users-
[EMAIL PROTECTED] On Behalf Of Chris Mason (Lists)
Sent: Saturday, April 30, 2005 5:59 PM
To: 'Asterisk Users Mailing List - Non-Commercial Discussion'
Subject: [Asterisk-Users] Problem with Sangoma/Adtran 600
Thanks for the advice. That was part of the problem, but also the Sangoma
stuff required I removed the modules from /etc/modules.conf and I had to
configure the DSO mapping in the channel bank, which I knew nothing about.
The Sangoma T1 card and the Adtran Channel Bank now work very well together,
Also, what version of the wanroute driver software are you using?
wanpipe-2.3.2-1
1. modprobe zaptel
Works.
[EMAIL PROTECTED] asterisk]# service zaptel start
Loading zaptel framework: [ OK ]
Waiting for zap to come online...Error: missing /dev/zap!
Chris Mason
www.anguillaguide.com
On May 1, 2005 08:36 am, Chris Mason (Lists) wrote:
Waiting for zap to come online...Error: missing /dev/zap!
Uh... the error seems obvious. Have a good look at the various READMEs in the
zaptel source directory.
-A.
___
Asterisk-Users mailing list
I made some progres on this. The udev issues were causing me problems.
I rectified this and was able to build zaptel successfully.
Wanrouter start works great.
[EMAIL PROTECTED] asterisk]# wanrouter start
Starting WAN Router...
Loading WAN drivers: wanpipe done.
Starting up device: wanpipe1
x lk x
x x Interface Name- w1g1x x
x x Operation Mode- TDM_VOICE x x
x x TDM Voice Span- 1
the same you want it to be linked to in zaptel.conf
so if you config it as span1 in zaptel.conf it has to say 1
On 5/1/05, Chris Mason (Lists) [EMAIL PROTECTED] wrote:
x lk x
x x Interface
I have installed Asterisk on a CentOS4 box and then installed Asterisk from
CVS.
I installed a Sangoma A101 and connected it to a Adtran 600 using a T1
Crossover cable. The 600 has 12 x FXS, 12 x FXO interfaces.
I ran through the wanpipe install instructions and configured it, now I can
run
5:59 PM
To: 'Asterisk Users Mailing List - Non-Commercial Discussion'
Subject: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation
I have installed Asterisk on a CentOS4 box and then installed Asterisk from
CVS.
I installed a Sangoma A101 and connected it to a Adtran 600 using a T1
