Hi!
Did you ever find the answer to your question?
I am getting the same message on the console every second:
== Primary D-Channel on span 1 down
== Primary D-Channel on span 1 up
== Primary D-Channel on span 1 down
== Primary D-Channel on span 1 up
== Primary D-Channel on span 1 down
Hi,
that is the usual behaviour on a P2MP BRI line. When idle the telco
will bring down layer 2 and layer 1. Bristuff will activate layer 1
and layer 2 again immediately.
best regards
Klaus
Am Donnerstag, den 27.01.2005, 16:01 +0100 schrieb Remco Barende:
Hi!
Did you ever find the answer
Remco Barende wrote:
Did you ever find the answer to your question?
I am getting the same message on the console every second:
== Primary D-Channel on span 1 down
== Primary D-Channel on span 1 up
== Primary D-Channel on span 1 down
== Primary D-Channel on span 1 up
== Primary D-Channel
The error is only visible however if I run * with -v
(but I guess I shouldn't see these messages nonetheless)?
No, I still have these messages, and was hoping RC5 would fix them. Nice to
know that upgrading won't help :-(
Are you running asterisk with -vv too? If I run it without verbose
The error is only visible however if I run * with -v
(but I guess I shouldnt see these messages nonetheless)?
No, I still have these messages, and was hoping RC5 would fix them. Nice to
know that upgrading wont help :-(
Are you running asterisk with -vv too? If I run it without
Hi
This is normal behaviour if you are running isdn in PTMP mode, at least in
sweden. It is bothering with these messages, but I'we been running my test
site with two PTMP lines for months and everything worked fine.
It is said that some operators keep trying to turn off the D-channel in
On Thu, 27 Jan 2005, Klaus-Peter Junghanns wrote:
Am Donnerstag, den 27.01.2005, 16:01 +0100 schrieb Remco Barende:
== Primary D-Channel on span 1 down
== Primary D-Channel on span 1 up
that is the usual behaviour on a P2MP BRI line. When idle the telco will
bring down layer 2 and layer 1.
Using the latest(?) bristuff (Asterisk 1.0.4-BRIstuffed-0.2.0-RC3a) I
have problems with loosing the D-channel. Most of the time, after the
message
PRI D-channel down
it only takes a second or so to come back up, noted by the message
PRI D-channel up
However, today most of the time the
