Re: QCA6174 hw2.1 irq_mode=0 broken on 4.2-rc3, working on 4.1.2

Hi there, sorry for the late and still no results. Life never goes as planned does it? I will still try to find the time to bisect this, however I cannot foresee when this might happen. If anybody has urgency to fix this might as well bisecting instead of waiting for me. My apologize :( Best

WLE600VX from PCEngines

Hi everyone, I have an interesting issue - I'm trying to run the QCA9882 based card in IBSS mode (to be used for BATMAN), however all I can do is to run in in 40Mhz channel width in 5GHz spectrum. Any attempt to run it in 80MHz width resolves in the following: Interface wlan0 ifindex 5

Re: WLE600VX from PCEngines

Sending again as a plain text. Regards, Tomasz Skąpski On 8 September 2015 at 21:03, Tomasz Skapski wrote: > Hi Marcel, > > you are using iw set freq command in a wrong way. You have to also inform > about the center frequency to use in case of 80 MHz bandwidth. Try

[PATCH v2] ath: use PRI value given by spec for fixed PRI

PRI value is used as divider when DFS detector analyzes candidate radar pulses. If PRI deviation is big from its origin PRI, DFS detector could miss valid radar reports since HW often misses detecting radar pulses and causes long interval value of pulses. For instance from practical results, if

Re: WLE600VX from PCEngines

On 8 September 2015 at 23:31, Marcel H. wrote: > Hi everyone, > I have an interesting issue - I'm trying to run the QCA9882 based card > in IBSS mode (to be used for BATMAN), however all I can do is to run > in in 40Mhz channel width in 5GHz spectrum. Any attempt to run it in >