Hi Aniket,
The main limitation for the number of SPI slave devices allowed in an
independent slave configuration is the number of CS lines available to you
and the ability for data and clock lines to meet threshold high and low
logic levels.
In the Arduino code provided in the tutorial you
Ok, this is the kind of thing you just can't make up and I'm REALLY not
trying to be the laughing stock of the internet, but here's what my issue
was.
The orientation of the mating Hirose connector on our PCBA breakout board
(which plugs up under the BB-X15/572Xevm) is rotated 180 degrees
OK.
I'll be glad to gather any data for you that I can.
I can grab some scope traces of what the power looks like.
I don't have anything that will do 24 hour long captures.
The bench supply I have is well regulated, and quiet, 5 Amp.
I have run two PB (on Vin P1-pin1) from the same supply
On Monday, November 27, 2017 at 2:05:41 PM UTC-5, mike.maikae...@gmail.com
wrote:
>
> OK, I got it: it seems, the Octavo-SoC does NOT support MLO as file on the
> FatSF partition. Writing it into the forst section of the SD card solved
> the problem, now the MLO is found and loaded.
>
This is
And the investigation continues in the following thread on E2E:
https://e2e.ti.com/support/arm/sitara_arm/f/791/p/649900/2388226#pi316653=1
Thanks and FYI,
On Monday, December 11, 2017 at 2:22:52 PM UTC-6, Jeff Andich wrote:
>
>
> My comments above about configuring the pinmux in u-boot SPL
On Thu, Dec 14, 2017 at 9:29 AM, 杜克禮 wrote:
> Hi All
>
> My BBBW had issue,Cannot booting from eMMC but SD card boot properly.
Plug in a usb-serial adapter into the debug port. What do you see
when you try booting from eMMC..
Regards,
--
Robert Nelson
Hi All
My BBBW had issue,Cannot booting from eMMC but SD card boot properly.
TKS
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving
Hi Robert
I am facing a problem simiar to yours. My project involvs connecting 4
arduino pro mini's as slaves to a Beaglebone black. I am able to share data
between one arduino and the beaglbone by following the link below
:http://www.ulasdikme.com/projects/arduino/BBB_Arduino_SPI.php
I
I know nothing about myoelectric prosthesis and the processing and real
time requirements for what this device is required to do.
Sounds like the thesis could entail an analysis of existing myoelectric
prosthesis currently available, and selection of a range of
computers/processors which are