hon.
Yan
-- Original Message --
From: "Zhu, Yan" <zhu...@nao.cas.cn>
To: casper@lists.berkeley.edu; dale.e.g...@njit.edu
Sent: 2018-03-08 15:25:55
Subject: Re[2]: [casper] KAT-7 KatADC on ROACH2
Hi Dale,
Thanks a lot for helping.
I applied the code, now the fpga clock spe
Hi Dale,
Thanks a lot for helping.
I applied the code, now the fpga clock speed returned by est_brd_clk()
is stable as expected value,
but the sine waveform is not quite good, as in zdok0/pol0 in attached
picture.
Any more suggestions?
Thanks again.
Yan
-- Original Message --
Hi Michael and all,
I'm also intended to use sync_out or other GPIO to output square wave to
control noise source,
I measured 6V for sync_out and GPIO pin 1.5V.
After digging into ROACH2 schematics(page 25 in
roach2_rev2_schematics.pdf),
I found the differential signal is first converted
Running casper toolflow on windows need a little modification of some .m files.
I recommend using xilinx officially supported linux distributions, RHEL 6 or
it's clone, centos 6, with casper toolflow. But if you insist running on
windows, contact me and I can give you some patch.
Good luck,
Try WaveScope block under Xilinx Blockset/Tools.
发件人: casper-bounces+zhuyan=nao.cas...@lists.berkeley.edu
[mailto:casper-bounces+zhuyan=nao.cas...@lists.berkeley.edu] 代表 Jay Brady
发送时间: 2013年9月6日 9:24
收件人: Casper List
主题: [casper] output a binary string in simulink?
Is there a way to look
I had a working copy of Matlab2012b, ISE14.4 on windows 7 sp1 64bit, and ska-sa
library compiled successfully, with only slight modification in OS checking
code in gen_xps_file.m.
The error message, as Wesley said, is just a warning and does not influence
following process. Ignore it or
and manually compile numpy,
matplotlib, ipython, katcp, corr etc.
Zhu Yan
On 4/5/2011 5:58 PM, Mark Wagner wrote:
Hi Miguel,
For 2, try opening a new model file and putting in the XSG_core_config
and System Generator blocks, pulling them from their libraries. Then
open up tut1 and copy everything
Hi Jesús,
Have you ever tried this trick
http://www.mail-archive.com/casper@lists.berkeley.edu/msg01070.html
for the crash case?
I'm also new to casper tools.
Cheers,
Yan
On 3/9/2011 5:31 PM, Jesús García wrote:
Hi,
In order to avoid the problems I had, I have started to work with Linux
8 matches
Mail list logo