Thanks very much Christophe - why does "sh int port-chan 10" show mtu of 9216?
Shouldnt it show 1500bytes?
# sh int port-channel 10
port-channel10 is up
Hardware: Port-Channel, address: 30f7.0da0.7378 (bia 30f7.0da0.7378)
Description: 20Gb_VPC_PEER_LINK_TO_TORSW02-EQ-SY3-1806B
MTU 9216
Uh...
Is it as simple as:
Interface vlan777
ipv6 enable
Otherwise, the config looks spot on
Our config looks like:
interface Vlan110
standby version 2
standby 110 ipv6 FE80::1
standby 110 timers 1 3
standby 110 priority 110
standby 110 preempt delay minimum 180
standby 110
On 03/03/16 09:17, Dario Amaya wrote:
Hi list,
I have a couple of Cisco boxes:
7604 / SUP720-3BXL - IOS 12.2(33)SRE
7204 / NPE-G1 - IOS 12.2(33)SRE
Firstly, can you advise if the config below is correct? Anything I am
It looks about right. A working HSRPv6 config from one of our 6500s:
Hi list,
I have a couple of Cisco boxes:
7604 / SUP720-3BXL - IOS 12.2(33)SRE
7204 / NPE-G1 - IOS 12.2(33)SRE
Firstly, can you advise if the config below is correct? Anything I am
missing? Secondly, I cannot get the ipv6 group 2777 to be
Active/Standby, both are in an Active state as you can
On 03/03/2016 02:10 AM, CiscoNSP List wrote:
> Yet "other" ports show 1500bytes:
>
> # sh int eth 1/1
> Ethernet1/1 is down (Link not connected)
> Dedicated Interface
> Hardware: 10/100/1000 Ethernet, address: 547f.ee7b.ff28 (bia 547f.ee7b.ff28)
> MTU 1500 bytes, BW 100 Kbit, DLY 10 usec
>
