On 7/18/19 1:09 AM, Richard Mikisa wrote:
> Issue was mismatched MTU. I reduced them down to 2000 after a ping
> sweep and its been steady since.
I would ping across the link with DF bit set and see what the maximum
size packet you can successfully transmit over the point-to-point and
set your
Hi all
Issue was mismatched MTU. I reduced them down to 2000 after a ping
sweep and its been steady since.
On Thu, Jul 18, 2019 at 3:18 AM Mike
wrote:
>
> On 7/17/19 6:54 AM, Łukasz Bromirski wrote:
> >> On 9 Jul 2019, at 17:58, Richard Mikisa wrote:
> >>
> >> Hi All,
> >>
> >> I am running
On 7/17/19 6:54 AM, Łukasz Bromirski wrote:
>> On 9 Jul 2019, at 17:58, Richard Mikisa wrote:
>>
>> Hi All,
>>
>> I am running OSPF across a point to point link between a Nexus 7000
>> and an ASR1000x.
>>
>> The OSPF works fine but every couple of hours, it breaks and neighbor
>> state goes into
> On 9 Jul 2019, at 17:58, Richard Mikisa wrote:
>
> Hi All,
>
> I am running OSPF across a point to point link between a Nexus 7000
> and an ASR1000x.
>
> The OSPF works fine but every couple of hours, it breaks and neighbor
> state goes into EXCHANGE and remains there for another 40 minutes
On Tue, 9 Jul 2019 at 21:01, wrote:
>
> Try removing the "ip ospf mtu-ignore" from both ends -see if the adjacency
> comes up (past exchange).
> Try enabling debug to see what exactly is going on -you should see straight
> away what the crux of the problem is.
>
> adam
^ This. Never use "ip ospf
ehalf Of Richard
> Mikisa
> Sent: Tuesday, July 9, 2019 4:58 PM
> To: cisco-nsp@puck.nether.net
> Subject: [c-nsp] OSPF flapping between Nexus 7000 and ASR 1001x
>
> Hi All,
>
> I am running OSPF across a point to point link between a Nexus 7000 and an
> ASR1000x.
>
&
9 11:58 AM
To: cisco-nsp@puck.nether.net
Subject: [c-nsp] OSPF flapping between Nexus 7000 and ASR 1001x
This message originates from outside of your organisation.
Hi All,
I am running OSPF across a point to point link between a Nexus 7000 and an
ASR1000x.
The OSPF works fine but every coupl
Multicast.
On 7/9/19 6:58 PM, Richard Mikisa wrote:
Hi All,
I am running OSPF across a point to point link between a Nexus 7000
and an ASR1000x.
The OSPF works fine but every couple of hours, it breaks and neighbor
state goes into EXCHANGE and remains there for another 40 minutes or
so. It
Hi All,
I am running OSPF across a point to point link between a Nexus 7000
and an ASR1000x.
The OSPF works fine but every couple of hours, it breaks and neighbor
state goes into EXCHANGE and remains there for another 40 minutes or
so. It then goes into full, OSPF comes up and all is well for
