Package: installation-reports

Debian-installer-version: Netboot beta 3 (2.6 kernel) 11-Aug-2006
http://ftp.nl.debian.org/debian/dists/testing/main/installer-sparc/beta3/images/sparc64/netboot/2.6/boot.img

uname -a: Linux (none) 2.6.17-2-sparc64 #1 Sat Aug 12 17:17:29 BST 2006
sparc64 unknown

Date: Fri Aug 25 22:10:31 EST 2006

Method: Installed by setting up a tftp server on another blade running
solaris 9. Created a /tftpboot directory with the above boot.img which
was successfully picked up by the b100 blade upon rebooting using "boot
net" method. However, it could not pick up the network interfaces (2xSun
Cassini 10/100/10000 Ethernet) and the installation cannot proceed any
further.


Machine: SUN Sun b100 (inside bx1600 chasis)
Processor: TI UltraSparc IIe (Hummingbird)
Memory: 1Gb


Output of lspci and lspci -n:

#lspci

00:00.0 Host bridge: Sun Microsystems Computer Corp. Ultra IIe
00:03.0 Non-VGA unclassified device: ALi Corporation M7101 Power
Management Controller [PMU]
00:07.0 ISA bridge: ALi Corporation M1533/M1535 PCI to ISA Bridge
[Aladdin IV/V/V+]
00:0a.0 Ethernet controller: Sun Microsystems Computer Corp. Cassini
10/100/1000 (rev 20)
00:0b.0 Ethernet controller: Sun Microsystems Computer Corp. Cassini
10/100/1000 (rev 20)
00:0d.0 IDE interface: ALi Corporation M5229 IDE (rev c4)


#lspci -n

00:00.0 0600: 108e:a001
00:03.0 0000: 10b9:7101
00:07.0 0601: 10b9:1533
00:0a.0 0200: 108e:abba (rev 20)
00:0b.0 0200: 108e:abba (rev 20)
00:0d.0 0101: 10b9:5229 (rev c4)

Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot worked:    [O]
Configure network HW:   [E]


Comments/Problems:

1. Booted OK from boot.img via "boot net"
2. Installer downloaded and started hardware detection - attempted to
install cassini module, but was unsuccessful. The log says:

cassini.c:v1.4 (1 July 2004)
cassini: Cannot find proper PCI device base address, aborting.
cassini: Cannot find proper PCI device base address, aborting.


Full dmesg log is:

#dmesg
PROMLIB: Sun IEEE Boot Prom 'OBP 4.11.5 2003/11/12 10:40'
PROMLIB: Root node compatible:
Linux version 2.6.17-2-sparc64 (Debian 2.6.17-6) ([EMAIL PROTECTED]) (gcc
version 4.1.2 20060729 (prerelease) (Debian 4.1.1-10)) #1 Sat Aug 12
17:17:29 BST 2006
ARCH: SUN4U
Ethernet address: 00:03:ba:7a:f2:82
On node 0 totalpages: 130182
  DMA zone: 130182 pages, LIFO batch:15
CPU[0]: Caches D[sz(16384):line_sz(32)] I[sz(16384):line_sz(32)]
E[sz(524288):line_sz(64)]
Built 1 zonelists
Kernel command line:
PID hash table entries: 4096 (order: 12, 32768 bytes)
Console: colour dummy device 80x25
Dentry cache hash table entries: 131072 (order: 7, 1048576 bytes)
Inode-cache hash table entries: 65536 (order: 6, 524288 bytes)
Memory: 1032064k available (2152k kernel code, 720k data, 144k init)
[fffff80000000000,000000005ff42000]
Calibrating delay using timer specific routine.. 11.12 BogoMIPS (lpj=22242)
Security Framework v1.0.0 initialized
SELinux:  Disabled at boot.
Capability LSM initialized
Mount-cache hash table entries: 512
checking if image is initramfs...it isn't (no cpio magic); looks like an
initrd
Freeing initrd memory: 2781k freed
NET: Registered protocol family 16
PCI: Probing for controllers.
PCI: Found SABRE, main regs at 000001fe00000000
SABRE: Shared PCI config space at 000001fe01000000
SABRE: DVMA at c0000000 [20000000]
PCI quirk: region 0800-083f claimed by ali7101 ACPI
PCI quirk: region 0600-061f claimed by ali7101 SMB
PCI-IRQ: Routing bus[ 0] slot[ a] to INO[22]
PCI-IRQ: Routing bus[ 0] slot[ b] to INO[23]
PCI-IRQ: Routing bus[ 0] slot[ d] to INO[20]
PCI0(PBMA): Bus running at 33MHz
isa0: [serial] [bscbus -> (bscv) (i2c)] [rtc] [power] [flashprom]
ebus: No EBus's found.
power: Control reg at 000001fe02000800 ... powerd running.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
NET: Registered protocol family 2
IP route cache hash table entries: 8192 (order: 3, 65536 bytes)
TCP established hash table entries: 32768 (order: 5, 262144 bytes)
TCP bind hash table entries: 16384 (order: 4, 131072 bytes)
TCP: Hash tables configured (established 32768 bind 16384)
TCP reno registered
audit: initializing netlink socket (disabled)
audit(1156507047.228:1): initialized
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 8192 bytes)
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Activating ISA DMA hang workarounds.
Console: switching to mono PROM 80x34
Real Time Clock Driver v1.12ac
[drm] Initialized drm 1.0.1 20051102
ttyS0 at MMIO 0x1fe020003f8 (irq = 7419008) is a 16550A
Console: ttyS0 (SU)
RAMDISK driver initialized: 16 RAM disks of 16384K size 1024 blocksize
loop: loaded (max 8 devices)
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
usbmon: debugfs is not available
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
mice: PS/2 mouse device common for all mice
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
RAMDISK: Compressed image found at block 0
VFS: Mounted root (ext2 filesystem).
cassini.c:v1.4 (1 July 2004)
cassini: Cannot find proper PCI device base address, aborting.
cassini: Cannot find proper PCI device base address, aborting.






begin:vcard
fn:Chi Nguyen
n:Nguyen;Chi
org:Macquarie University;Meta Access Management System
adr:;;;Sydney;NSW;2109;Australia
email;internet:[EMAIL PROTECTED]
title:Research Coordinator
tel;work:+61 2 98509077
tel;fax:+61 2 98506527
url:http://mams.melcoe.mq.edu.au
version:2.1
end:vcard

Attachment: smime.p7s
Description: S/MIME Cryptographic Signature

Reply via email to