Hi Team, we have 27 machine del r730, with this network card lspci | grep net 01:00.0 Ethernet controller: Intel Corporation Ethernet Controller X710 for 10GbE SFP+ (rev 01) 01:00.1 Ethernet controller: Intel Corporation Ethernet Controller X710 for 10GbE SFP+ (rev 01) 07:00.0 Ethernet controller: Intel Corporation I350 Gigabit Network Connection (rev 01) 07:00.1 Ethernet controller: Intel Corporation I350 Gigabit Network Connection (rev 01)
Only em1 and em2 are enable ethtool -i em1 driver: i40e version: 1.0.11-k firmware-version: f5.0 a1.5 n05.04 e800024bc bus-info: 0000:01:00.0 supports-statistics: yes supports-test: yes supports-eeprom-access: yes supports-register-dump: yes supports-priv-flags: no ethtool -i em2 driver: i40e version: 1.0.11-k firmware-version: f5.0 a1.5 n05.04 e800024bc bus-info: 0000:01:00.1 supports-statistics: yes supports-test: yes supports-eeprom-access: yes supports-register-dump: yes supports-priv-flags: no this are in bonding configuration ALB mode ip a 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever 2: em1: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 9000 qdisc mq master bond0 state UP qlen 1000 link/ether f8:bc:12:14:34:e0 brd ff:ff:ff:ff:ff:ff 3: em3: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN qlen 1000 link/ether f8:bc:12:14:35:00 brd ff:ff:ff:ff:ff:ff 4: em2: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 9000 qdisc mq master bond0 state UP qlen 1000 We receive many errors with this message on em1 and em2 interface : Sep 16 17:05:49 PRB163 kernel: i40e 0000:01:00.1: TX driver issue detected, PF reset issued Sep 16 17:05:50 PRB163 kernel: i40e 0000:01:00.1: FCoE capability is disabled Sep 16 17:05:50 PRB163 kernel: i40e 0000:01:00.1: i40e_ptp_init: added PHC on em2 Sep 16 17:05:50 PRB163 kernel: i40e 0000:01:00.1 em2: NIC Link is Up 10 Gbps Full Duplex, Flow Control: None Sep 16 17:05:50 PRB163 kernel: bonding: bond0: link status up again after 0 ms for interface em2 Can you help us ? Regards Christian Marangoni ------------------------------------------------------------------------------ _______________________________________________ E1000-devel mailing list E1000-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/e1000-devel To learn more about Intel® Ethernet, visit http://communities.intel.com/community/wired