> Ugh, I have my K2 upgrade changes made, but the PLL is not cooperating. This
> is after all the A to B changes, including specifically the PLL temperature
> compensation upgrade, which includes the new crystal X1 and the thermistor
> board replacing the resistor pack.
Went back to original
Ugh, I have my K2 upgrade changes made, but the PLL is not cooperating. This is
after all the A to B changes, including specifically the PLL temperature
compensation upgrade, which includes the new crystal X1 and the thermistor
board replacing the resistor pack.
The counter works fine, tested
Here is the list of stations checking in to the 20 m ssb net. Thank you again
to the net control stations whose help is invaluable in being able to receive
stations out of range of the net control station.
The net meets at 1800Z. on a frequency of 14.303.5 and all are welcome.Eric
WB9JNZ
Call
On 11/30/2020 2:00 PM, Arkady via Elecraft wrote:
When I “run” I get fan starting running after 10-15 minutes.
This happens to me when "running" with few callers on CW, sooner on
RTTY, and within 5 minutes or less with WSJT modes. I've not experienced
the other behavior you describe.
73,
Hello,
I wonder if anybody had similar problem.
When I “run” I get fan starting running after 10-15 minutes. However after
another few minutes of running the fan will shuts down every time I press a key
( I am CW op). As a result the temperature of the PA goes higher and higher and
at certain
The band was strong with great participation.
Thanks to all for checking in and for those assisting with relays.
WM6PSTEVEGA K3S NET CONTROL
WY3T TIM FL K3S
KB9AVO PAUL IN K3S
K8NU CARL OHK3S
N0MPM MIKEIA K3S
K1NW BRIAN
Ok on that, I did check that in menu, re 'AUTO OFF', and it is and was
set to 'infinite'.
There is also an 'ALARM' parameter with beeps, that turns the KX3 on,
not off.
The beeps heard before off was intriguing. I didn't see any screen
warnings at the Bezel.
Thankyou
On 1/12/20 12:58
I had that same problem. Check that you haven't set the timer to turn
off the radio after a certain period.
david
KC1DNY
On 11/30/2020 7:01 AM, Adrian wrote:
I have a KX3 that sometimes just turns off, after sitting idle. and
sometime 2-3 beeps are heard prior.
Have done much googling and
I have a KX3 that sometimes just turns off, after sitting idle. and
sometime 2-3 beeps are heard prior.
Have done much googling and can't find this scenario. Has anyone seen
this ?
Power supply is good at 15v solid from a battery bank, so there is no
supply power interruption.
It may
9 matches
Mail list logo