Re: [Elecraft] K3 and Tascam US-122MKII

Deane: I have the US-144, but it is similar enough to be applicable. I use the Elecraft Line Out with a stereo cable to the Tascam Line In (L) jack. You will need to use a 1/8 to 1/4 adapter to make this work. I use the L and R line out jacks (RCA) with an RCA to stereo 1/8 adapter. This goes

[Elecraft] NUE-PSK and the K3/100

I'm querying the group regarding the NUE-PSK settings and an Elecraft K3 ... I'm having some trouble getting the transmit settings correctly. Here's what I've done so far ... after Googling, reading, and experimenting ... MODE: Data A Power set at 20 watts Line Out is from the back of the K3

[Elecraft] OT O'scope power cord

I have been given a wonderful Tektronix 561A dual trace o'scope. However it does not have a power cord. Does anyone have a power cord for this unit ... or suggestions for modifying a power connector to fit the scope? Thanks. Off the reflector responses are fine. 73, gene KC0RXY

[Elecraft] Non-resonant loop

What a *great* group of suggestions! Thanks much for the ideas. Thanks to you all, I'm armed and dangerous as I go explore the RF capabilities of the new QTH. My K1-4 will be happy as a clam ... and the 706MkIIG won't mind either. They were sad to leave the 180' long wire. I was sad to leave

[Elecraft] Non-resonant attic loop

I'm needing to install an antenna in my new home. An attic loop is a necessity ... can't run an outside wire easily. I'm assuming that an 88-ft loop will be non-resonant in all bands 80-10, and fed with ladder line to the tuner should work. Other suggestions? Thanks. gene KC0RXY soon /9

Re: [Elecraft] Non-resonant attic loop

Good points, Bob. And ... errr ... no, not exactly I know it is 20+ feet above the ground, so far so good. We are moving 500 miles from our present QTH, and I didn't have a ladder to get to the attic opening when we were shopping for a house. I do know that outside, I'll have a

[Elecraft] Re: K1-4 Filter Board New Trimmer Caps

Vin: Just assembled K1 #1945 with the K1-4 option. Like you, I had some questions about the new trimmer caps during assembly. I did my best with understanding the directions and still installed them backwards ... consistently though. The only problem with installing them backwards is that

[Elecraft] KFL1-4 trimmer pots

OK, I'll show my *newbie* state. I've built several Dave Benson kits, but the K-1 is my first Elecraft kit. I was installing the new style trimmer pots on the KFL1-4 board. I read the manual and I thought that I carefully read the errata sheet ... turns out that I didn't. I put the trimmer