Re: [Elecraft] My photos of the KPA1500 from Visalia, and a Y-BOX update

Isn’t 14060 the QRP frequency on 20M? Regards, Danny G3XVR From: Bob Wilson, N6TV Sent: 26 April 2017 02:36 To: Elecraft Reflector Subject: [Elecraft] My photos of the KPA1500 from Visalia, and a Y-BOX update If you'd like to see what a KPA1500 looks like next to a K-line, start here:

Re: [Elecraft] K3 loss of rx signal

I had a similar frustrating problem with a BNC patch lead. I bought some cheap leads at a rally and I didn’t notice that the plugs were 75 Ohms. The leads worked OK, but the centre pin was thicker than the 50 Ohm version and it splayed out the centre connector of the socket, so when I plugged a

Re: [Elecraft] (no subject)

I have the same problem. There is a Safe Mode (somewhere?) which allows you to do this, otherwise the K3S goes to transmit when controlled by USB and the PC is turned off. Regards, Danny Higgins From: Jeff Sent: 24 October 2016 14:24 To: Elecraft@mailman.qth.net Subject: [Elecraft] (no

Re: [Elecraft] Antenna Question

Hi David. Thanks for the information. I ordered some compression PL259s and SO239s yesterday direct from Barenco, and they arrived this morning, at a fraction of the cost I last paid from a retail Ham supplier. They look quite chunky with protective caps on the end, which I would not expect