Elecrafters, sorry for slightly off topic.
I run a K3 with LPPan and PowerSDR I/F Stage.
I'm trying to output the I/Q signal via VAC to CW-skimmer, but i get
only garbage on the skimmer waterfall.
The same setup works fine when i switch off I/Q and only direct the
normal audio to cw-skimmer
, there is not
enough time for the next good one to get to the rig.
73,
Larry N8LP
On 9/2/2013 10:03 PM, elecraft-requ...@mailman.qth.net wrote:
Date: Mon, 2 Sep 2013 18:11:20 -0700 (PDT)
From: Chuck - AE4CWae...@att.net
To:elecraft@mailman.qth.net
Subject: Re: [Elecraft] CW skimmer setup question
Message-ID
Mike,
1. I have set hardware to softRock-IF (as per LP Pan site) is this
correct?
OK
2. Sampling rate I am going to use is 96 and I did set the same on
the E MU 0202
OK, but 192khz also should work.
3. Pitch is set to 600 as is the K3
OK
4. The Audio IF I am not sure what to set
Mike,
Please see my embedded responses below:
Just downloaded CW skimmer and am using it with the LP Pan, E MU 0202 and of
coarse the K3. I am in the process of setting things up and has some
questions. As well just wanted to share the setup options I chose just to
make sure they are ok.
Under
Just downloaded CW skimmer and am using it with the LP Pan, E MU 0202 and of
coarse the K3. I am in the process of setting things up and has some questions.
As well just wanted to share the setup options I chose just to make sure they
are ok.
Under the settings taband then to the radio tab
The best place to get answers is the LP-PAN website. It has very complete
instructions for both hardware and software.
http://www.telepostinc.com/LP-PAN.html
For example, here's the page for the E-Mu 0202:
http://www.telepostinc.com/emu0202.html
If you still have questions after reading the
6 matches
Mail list logo
