Hi,
Thanks, and no need, to apologize, sometimes mail lists make it
difficult to communicate... The addition of a single word can change
the meaning of things... No offense taken.
--
Thanks and 73's,
For equipment, and software setups and reviews see:
www.nk7z.net
for MixW support see;
No. Obviously. There is no TX output path sampling built into the P3. This
can be seen by studying the manual. There has always been however, a large
empty hole in the back of the P3 labeled sensor. Therefore (obviously)
space left for a future sensor.
You know it's not that obvious to me. If I have to study the manual,
or look at the back of the rig, it is not obvious...
--
Thanks and 73's,
For equipment, and software setups and reviews see:
www.nk7z.net
for MixW support see;
http://groups.yahoo.com/neo/groups/mixw/info
for Dopplergram
It's not all that obvious that you're likely to get hit by a
bus when you step off the curb in the middle of a block either
- unless you *look*!
The fact that the P3 has this large hole in the back panel
marked Sensor with no connector makes it obvious on even
a cursory inspection that there is
OK, Study was not the right term. It's a matter of knowing the basic
functions and capabilities of a piece of equipment. Best done by reading
(not studying) before assuming. For those of us who have had the P3 for some
time, this _was_ obvious. My apologies.
Bruce N1RX
One could read the literature prior to purchase i spose?
Gary
Vk1ZZ
K3, KX3, KPA500-FT, KAT500-FT,P3.
On 10/12/2014 1:24 PM, Bruce Beford bef...@myfairpoint.net wrote:
OK, Study was not the right term. It's a matter of knowing the basic
functions and capabilities of a piece of equipment. Best
The literature as it exists does not indicate that the P3 is capable of
doing any transmit monitoring - no mention of the sensor jack.
The fact that there is a jack on the back of the P3 that is marked
SENSOR is akin to the jack on the bottom of the K3 that is defined as
for factory use only.
7 matches
Mail list logo