Thank you very much to KR2F, AB9CA, AC7AC, K7SVV, KB9BVN, K4ZM and N0SS and
others for the usefull information.
I will ask Elecraft for new earphone jack to replace.
73, Ruchan Ozatay, TA2AH
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
Hi guys,
To day, first time I started to use my K1 (2040) with headphone (headphone for
walkman) and it worked perfectly. After a while I disconnect headphone to use
it with its own speaker but the speaker didn't work. I checked headphone again
and again it was OK but when I disconnect it
3:51 PM
To: elecraft@mailman.qth.net
Subject: [Elecraft] K1 (2040) speaker dead
Hi guys,
To day, first time I started to use my K1 (2040) with headphone (headphone
for walkman) and it worked perfectly. After a while I disconnect headphone
to use it with its own speaker but the speaker didn't work
Ruchan,
This is a known problem with both the K1 and K2. The earphone jack goes bad. Must
replace it. Quite a chore.
Right now the jack on my K2 is open on the speaker side, just like your's. I've already
replaced the jack on my K1 and was hoping I wouldn't have to do this on the K2, but
My seven-year-old K2 has yet to experience a phones jack problem. That might
be just luck, but I have done something a little different that might help
as well.
I use a lightweight pigtail with a plug in the K2 instead of hooking the
phones directly to the jack. I did that because my favorite
Hi all,
I am now building RF Boar, Part I. I have to install ceramic trimmer capacitors
(C13 and C20). The flattened side must be oriented towards the flattened side
of the component outline, but the outline on my board is not clear enough.
Can some one help me to find which side of the
[EMAIL PROTECTED] wrote:
Strange, I am at the same point (SN 2033) and have the same question. The
outline on the circuit board for C13 and C20 does not have a flat side I can
see. Any one have the top cover of the K1 off ?
Look at Appendix F in the manual.
In my manual the flat side of
7 matches
Mail list logo