Ok I now have audio.I can hear "hiss" fairly loudly as well as strong
sidetone when I go into the stl menu. I replaced C11 and audio sprung to
life.
I proceeded to wind L1 and installed it, then re-installed my filter board
and now I get the E42, "No VFO." I can go into the menus and
Problem solved, thanks for the pointers Don! In checking the RF board and
filter board over and over, I disassembled the front-panel board again,
resoldered pin 10 on J1 since it didn't look as good to me as it could have
been and then, as I went over everything I found an unsoldered leg on R11.
John, great to hear.
Most of us have graduated to a 6” loop that is lighted.
Frank KG9H
> On Jan 11, 2016, at 10:48 AM, wingman67 via Elecraft
> wrote:
>
> Problem solved, thanks for the pointers Don! In checking the RF board and
> filter board over and over, I
lol! Not a bad idea Frank! :)
John
KD8UDZ
-
John Hines
--
View this message in context:
http://elecraft.365791.n2.nabble.com/K1-no-audio-tp7612521p7612535.html
Sent from the Elecraft mailing list archive at Nabble.com.
__
I have recently built up a K1 to the point of the receiver alignment (page
36, 7 "Alignment and Test, Part 1"). Up until this point all of my test
points have been successful, voltages correct, etc. When I power on the K1
I get the correct LED test pattern and then the E27/E42 error messages
I find the KX1's CW feedback announcements incredibly useful while
operating mobile. Eric/Wayne - have you considered incorporating this
wonderful feature into a future firmware version for the K1?
I'm particularly impressed with how well it's implemented: it announces the
frequency only when
6 matches
Mail list logo