My audio will distort and cut out as you describe if it's a very
strong AM signal (nearly full scale on the s-meter) and the volume is
turned up to that extreme. But that is really loud. I usually have the
AF Gain set at 1/4 rotation or less, so don't really consider it a
problem here. I never unde
If you're using the 2.8 or 2.1 filters for AM mode reception, it would
probably sound distorted. The 2.8 works fine for listening to AM in
SSB mode though.
matt W6NIA
K3 #24
On Sat, 05 Dec 2009 21:50:28 -0800 (PST), you wrote:
>
>Hey Joe,
>
>Thanks for the fast reply!
>
>No, I do not have the
What firmware rev are you using?
--- On Sat, 12/5/09, Richard Jones - KJ5QY wrote:
From: Richard Jones - KJ5QY
Subject: [Elecraft] K3 Distorted Sound while using AM
To: elecraft@mailman.qth.net
Date: Saturday, December 5, 2009, 9:50 PM
Hello,
I am having a problem when I go into AM, or AM
mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Richard Jones - KJ5QY
Sent: Saturday, December 05, 2009 11:50 PM
To: elecraft@mailman.qth.net
Subject: Re: [Elecraft] K3 Distorted Sound while using AM
Hey Joe,
Thanks for the fast reply!
No, I do not have the AGC Off, nor have I changed any of t
Behalf Of Richard Jones - KJ5QY
Sent: Saturday, December 05, 2009 11:50 PM
To: elecraft@mailman.qth.net
Subject: Re: [Elecraft] K3 Distorted Sound while using AM
Hey Joe,
Thanks for the fast reply!
No, I do not have the AGC Off, nor have I changed any of the "settings"
within the AGC (
Hi,
I've encountered the same once. It took me awhile to notice that the
distortion on AM was caused by the NB or NR being switched on. Might
this be your problem too?
73,
Frank PA4N
At 06:50 06/12/2009, Richard Jones - KJ5QY wrote:
>Hey Joe,
>
>Thanks for the fast reply!
>
>No, I do not ha
Hey Joe,
Thanks for the fast reply!
No, I do not have the AGC Off, nor have I changed any of the "settings"
within the AGC (Menus). I should have stated that in my original post.
Anyway, I am really stumped as what the problem is.
If you happen to have a K3 equipped as mine, could try to
Hi Rick,
Do you perhaps have AGC turned off and the AF LIM set to a value of
less than 30? The distortion and eventual cutting out of audio at
high levels you are describing sounds a lot like the intended AF
limiter action. If so, the solution is to either turn on AGC, or
increase the AF
Hello,
I am having a problem when I go into AM, or AM sync. Example: I go to an
AM Shortwave station. If I turn the AF gain past approximately 3/4 or
farther the radio starts to "Stutter, Distort, and finally the audio
disappears. I cannot make out what is coming out from my speaker. The
aud
9 matches
Mail list logo