I think you meant Figure 6 on page 10
On 19/1/08 00:45, Ron D'Eau Claire [EMAIL PROTECTED] sent:
Probably the best way to describe it is to refer you to Figure 10 on page 10
in the XV Owner's manual available here:
http://www.elecraft.com/manual/XV%20Transverter%20Owner's%20Manual-D.pdf
--
Yep G.
Ron
-Original Message-
From: David Ferrington, M0XDF [mailto:[EMAIL PROTECTED]
Sent: Saturday, January 19, 2008 1:00 PM
To: Ron D'Eau Claire; 'Gil Cross'; Crafters; [EMAIL PROTECTED]
Subject: Re: [Elecraft] K3 I/O Caution
I think you meant Figure 6 on page 10
On 19/1/08 00
I've been having intermittent computer problems with the K3 connected
ever since installing the K3 on the operating desk. The ultimate
disaster occurred during the RTTY Roundup when the computer shut itself
off and lost my log with approximately 1100 QSO's. After making various
attempts to
: [Elecraft] K3 I/O Caution
This missive caused me to look at my installation also. I found that
the situation was not good. The contacts in the db9m connector made very
minimal contact. In fact the retaining screws would not draw the connectors
together fully and if the connectors were forced
This worked for me too. An added tip is one I got from Wayne when
experiencing RF feedback on PSK31: Seat the two KIO3 rear panel
connector boards (3.5mm fems, and also the RCA / 1/4 phono) so that
there is a slight amount of interference with the screw-on panel. This
allows the grounds for the
: Friday, January 18, 2008 8:11 AM
Subject: [Elecraft] K3 I/O Caution
I've been having intermittent computer problems with the K3 connected ever
since installing the K3 on the operating desk. The ultimate disaster
occurred during the RTTY Roundup when the computer shut itself off and
lost my log
6 matches
Mail list logo
