I have noted something similar - say you set to fine tuning so you have a
frequency like 14.28. Then set to faster tuning rate. Tune down and up.
You find you are on 14.28001, there is no way to zero the last digit again.
Not that it matters but it is odd - perhaps a rounding error.
I don't
AD6XY wrote:
I have noted something similar - say you set to fine tuning so you have a
frequency like 14.28. Then set to faster tuning rate. Tune down and
up. You find you are on 14.28001, there is no way to zero the last digit
again. Not that it matters but it is odd - perhaps a
Mike
Practice using the direct frequency entry.
It is fast and gets you right on frequency.
Good luck and 73
Bob N6Wg
- Original Message -
From: AD6XY [EMAIL PROTECTED]
To: elecraft@mailman.qth.net
Sent: Monday, July 21, 2008 11:33 PM
Subject: Re: [Elecraft] K3 Momentary breaks when
Julian, G4ILO wrote:
Why not use the RIT control for fast QSYing?
I do, it does not.
--
View this message in context:
http://n2.nabble.com/K3-Momentary-breaks-when-tuning-down-tp574200p577343.html
Sent from the Elecraft mailing list archive at Nabble.com.
This was corrected in the last several beta f/w releases. We just put
beta release 2.19 on the web site. Load it into the K3 and this should
go away.
73, Eric
David Andrews wrote:
I'm aware when tuning down a band on receive that there is a short break in
the audio every so often. This
I'm aware when tuning down a band on receive that there is a short break in
the audio every so often. This doesn't seem to happen when tuning up the
band. Can anyone explain what is happening?
David G4CWB
___
Elecraft mailing list
Post to:
Hello David this problem was cured in beta release 2.15 see release notes
on the K3 firmware page, I had the problem but only on 80 meters
73 Peter G3MLO.
David Andrews-3 wrote:
I'm aware when tuning down a band on receive that there is a short break
in
the audio every so often. This
7 matches
Mail list logo