AM 03:35:12 BST
To: elecraft@mailman.qth.net
Subject: [Elecraft] K3 SSB Power Control and ALC Metering
Michael,
I also see the exact same symptoms you describe below. This is after
implementing Wayne's procedures 'to the letter.' Firmware V2.38, K3 S/N
775.
73,
Kam N3KS
Thanks
Hi,
Does this not happen to anyone else?
Re: a) - I've never noticed this. But it might be occurring.
Re: b) - I've seen my K3 do this. If I set the power in CW or Tune
mode, and don't touch the power control, usually the power level will
stay constant in SSB. With my K3 the problem
Thanks for that very useful guide, Wayne. Much appreciated.
I searched to see if others had been written but failed to find any more, which
is a pity because such gems seem worthy of their own little archive place.
73 DaveL G3TJP
___
Elecraft
Michael,
I also see the exact same symptoms you describe below. This is after
implementing Wayne's procedures 'to the letter.' Firmware V2.38, K3 S/N
775.
73,
Kam N3KS
Thanks for the detailed information. However, this is not my problem.
The most severe problem I have is:
a) the output
There's been some recent discussion of how to properly set up the K3 in
SSB modes. I meant to respond sooner but was out of town for several
days.
MIC GAIN SETTING: Adjust MIC gain for an ALC meter peak at around 5 to
7 bars during normal speech (rev. D owner's manual, page 28). This
5 matches
Mail list logo