Re: [Elecraft] K3 WSPR 2, ver 1.6

2016-07-02 Thread hb9brj
Ai4PF wrote > everything works fine on WSP 2 except I never see any of my numerous TX's > in the database. Do you receive (decode) other WSPR stations? If yes, frequency and PC time are ok. During TX, does your ALC show 4-5 bars? 73, Markus HB9BRJ -- View this message in context:

[Elecraft] K3 WSPR 2, ver 1.6

2016-06-30 Thread Ai4PF
Hello All: With lots of help from the Reflector, everything works fine on WSP 2 except I never see any of my numerous TX's in the database. Any help with this vexing problem is much appreciated.Bill, Ai4pf -- View this message in context:

[Elecraft] K3 WSPR settings that work for me

2013-01-16 Thread Dennis Moore
There are various discussions both on and off this list about how to set up the K3 with the Signalink USB when using WSPR, but I ran into a problem with the K3 staying in XMIT after sending was complete. Solutions were available online, just none that solved my issue. These settings got my K3

Re: [Elecraft] K3 WSPR

2009-11-21 Thread Julian, G4ILO
Eric Swartz - WA6HHQ, Elecraft wrote: No worries. That's a normal amount of heat. We also heatsink one of the DC voltage regulators to the right side of the case. That's most of the heat you are feeling. No way you will hurt anything at that low of a power (or higher). It would

Re: [Elecraft] K3 WSPR

2009-11-21 Thread Eric Swartz -WA6HHQ, Elecraft
Hi Julian, Its perfectly OK to run the LPA at 10W for long TX periods on WSPR and related modes. The K3 bottom case area is designed as its LPA heatsink and its normal for that to be quite warm after long TX periods. And we're -way- below the max temp specs for the PAs in the LPA. We've

[Elecraft] K3 WSPR

2009-11-20 Thread eric norris
My K3 is now up and running with WSPR 2.0 under CAT control, but WSPR only changes the freq not the mode or power--if this is not right and someone knows what dumb error I might be making, please email me off list. Also, even running at 1watt out, 20% TX cycle, the right side of the rig gets

Re: [Elecraft] K3 WSPR

2009-11-20 Thread Brian Machesney
Eric, force the PA on even at low power to keep things cool I don't know about that, but you can force the PA fans on by: - Press the POWER button to turn the K3 on - Hold CONFIG to select the Configuration menu, then turn VFO B to KPA3 - Turn the VFO A knob to PAIO ON... further to PAIO

Re: [Elecraft] K3 WSPR

2009-11-20 Thread Eric Swartz -WA6HHQ, Elecraft
No worries. That's a normal amount of heat. We also heatsink one of the DC voltage regulators to the right side of the case. That's most of the heat you are feeling. No way you will hurt anything at that low of a power (or higher). 73, Eric WA6HHQ Elecraft === eric norris wrote: My K3 is