Hi David;
You can tap DISP and rotate VFO B knob to see the current. Then set "tun
pwr" to nor, select desired power out, and long press XMIT to send a
carrier and see the current.
(do not TX at exactly 5 or 50w as that will cause a TX gain calibration).
That will give you a close reading.
The
Morning group,
After spending some time searching, I cannot find a table of measured current
draw versus power output for the K3. I’m working on how much battery I need for
portable ops and this information would be good so I can estimate the energy
requirements for my system.
There is an old
[EMAIL PROTECTED]
To: 'Edward R. Breneiser' [EMAIL PROTECTED];
elecraft@mailman.qth.net
Sent: Sunday, November 04, 2007 4:17 PM
Subject: RE: [Elecraft] K3 Current Draw?
Hi, Ed:
The K3 Owner's manual Specifications page has the data:
TX: 17-22A typical for K3/100, 3-4A typical for K3/10.
RX
Hello all,
I ordered my K3 in August. I tried to find the specs on the current draw
in Rx and TX, but no joy. Why aren't these specs listed on the data
sheet?
72,
Ed, WA3WSJ
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a
@mailman.qth.net
Subject: [Elecraft] K3 Current Draw?
Hello all,
I ordered my K3 in August. I tried to find the specs on the current draw in
Rx and TX, but no joy. Why aren't these specs listed on the data sheet?
72,
Ed, WA3WSJ
___
Elecraft mailing
5 matches
Mail list logo