I wish more would do the honour of letting the list know the cure.
Regards,
Mike VP8NO
On 14/06/2021 13:18, Michael K Bottles via Elecraft wrote:
No worries Lance, I hate to tell you how often I have performed “Operator
Error”!
Kim - K7IM
Sent from my iPad
On Jun 14, 2021, at 09:16, Lance
utotuner. Currently tuning a doublet, but will be
> tuning a longer wire soon (most likely a loop).
>
> Lance
> KK4DX
>
> -- Original Message --
> From: "Andy Durbin"
> To: "Lance HP"
> Sent: 6/14/2021 11:03:49 AM
> Subject: Re: Re[4]: [Elecraft] KAT
AM
Subject: Re: Re[4]: [Elecraft] KAT500 Tuner antenna selection stuck in
#2 position
With the configuration shown all antennas should have been selectable
on 160 m. I assume your did not make a screen shot with band selected
to the band that exhibited the problem.
Having the same enabled anten
""Last resort" tried and in the factory default configuration, the
antenna ports are changeable."
Good to know it isn't a hardware problem.
Can your please take a screen shot of the configuration/antenna tab with "band"
selected to a band that exhibits the problem. Email direct to me or post a
4/2021 9:53:52 AM
Subject: Re: [Elecraft] KAT500 Tuner antenna selection stuck in #2
position
"haven't tried to erase all my settings and revert back to factory default
settings...yet. I was only going to do that as a last resort."
There is no reason this should be "last resor
"haven't tried to erase all my settings and revert back to factory default
settings...yet. I was only going to do that as a last resort."
There is no reason this should be "last resort". Save the current
configuration, test with factory default configuration, then restore saved
configuration.
. There are no relay clicks from this action.
Lance, KK4DX
-- Original Message --
From: "Phil Hystad"
To: "kk4dx"
Cc: elecraft@mailman.qth.net
Sent: 6/13/2021 12:46:57 PM
Subject: Re: [Elecraft] KAT500 Tuner antenna selection stuck in #2
position
I have had a similar pr
, KK4DX
-- Original Message --
From: "Andy Durbin"
To: "elecraft@mailman.qth.net"
Sent: 6/13/2021 8:40:30 PM
Subject: [Elecraft] KAT500 Tuner antenna selection stuck in #2 position
"I cannot change the antenna selector via the front panel of the KAT500 or the
"I cannot change the antenna selector via the front panel of the KAT500 or the
utility software."
What was the KAT500 mode when you observed this problem? There is a known
firmware defect that may prevent enabled antennas being selected when mode is
BYP. The same problem does not exist if
I have had a similar problem and in my case I was not looking at the right spot
for adjusting the antennas.
There are two different spots when using the KAT500 utility. The Operate menu
selection and then also the Configuration\Antennas selection.
In my case, the Operate page would not let me
Anyone have this happen to them?
I cannot change the antenna selector via the front panel of the KAT500 or
the utility software. The utility software is working as I can remotely
cycle through the modes, but the antenna selector is stuck. All antenna
positions are checked (enabled) in the utility
11 matches
Mail list logo