as backup
Ulf, DL5AXX
K3 #1748
_
Von: elecraft-boun...@mailman.qth.net
[mailto:elecraft-boun...@mailman.qth.net] Im Auftrag von Randy Downs
Gesendet: Sonntag, 28. Dezember 2008 03:52
An: Gary Surrency; supp...@elecraft.com; Elecraft Reflector; Greg
Betreff: [Elecraft] KRX3 Problem Update
K8RDD wrote:
It seems my second receiver has went deaf. . . Suggestions?
Check the filter configuration for the subreceiver. Use the K3 Utility and
go to Configuration - Edit Crystal Filters - Sub Receiver. Make sure you
have the correct filters enabled.
73,
Barry N1EU
--
View this
Message -
From: Greg
To: Randy Downs
Sent: Friday, December 26, 2008 11:05 PM
Subject: RE: [Elecraft] KRX3 Problem
Possible but I would not think that would go out like that when it was
working when you shut downthen not when you powered up the next day. As
for what levels
Ok I have some Hunan chicken and it was great. Also I found that the relay K19
on the KAT3 was inverting my ant selection for the sub. If I selected 1 for
both then the sub was actually on 2 and visa versa. Don't know why or how. I
actually measured the connections with an ohmeter to the tmp
After several pots of coffee, the problem was found. I gotta take up drinking.
The problem was on the subin board. T1 toroid, 2 of the wires did not have all
of the coating removed and did not take the solder well. Very evident after
tracing it down to the board. I wicked the solder out and
It seems my second receiver has went deaf. A 20 over signal gives me about an
s3 on the sub. I can barely hear the signal phone or cw. I unplugged the tmp
connector at the KAT3 and jumped the dipole directly into it with the same
results. Deaf all modes all bands. I checked connections etc and
I installed a KRX3 and all is well with operating the front panel
controls until you select the sub rx, then the press and hold functions
don't work and the radio wants to scan when I turn the dial
The K3 display begins a scan when I try to tune it to a precise freq
that is a mult of 10
7 matches
Mail list logo