I found it very hard to get the screw tight enough that the paddle
didn't wobble, on two different KX-1's. Because of the position of the
key jack on the PC board, the hole in the paddle didn't line up with the
tapped hole in the case. (This was in the left-handed position; I
didn't check
Any ideas on keeping the paddle screw tight?
Mine seems to work loose easily, Locktite or similar
would work but I want to remove it.
The paddle on the KX-1 works loose because the thumbscrew strikes the edge of
the circuit board before the paddle body is pulled up tight against the
If the problem is that the screw end is contacting the board, there is
yet another way to correct it - put a #6 washer permanently on the
thumbscrew before screwing it into the paddle body. I use a light
spring lockwasher on mine. I would not suggest using an internal tooth
lockwasher
3 matches
Mail list logo
