It is rare for any KX1 to be "toast". Unless you have done significant
damage to the board, it is repairable. Even board damage can be handled
by removing the parts from the old board and using them on a new board.
A little work, certainly, but it can be done.
If you can wait for a time, I c
SN 2626 is toast.
73
--
View this message in context:
http://elecraft.365791.n2.nabble.com/KX1-ATU-low-power-tp7558478p7558756.html
Sent from the Elecraft mailing list archive at Nabble.com.
__
Elecraft mailing list
Home: http://mailman
You will get a response if you contact supp...@elecraft.com as shown in your
manual.
Apparently no one had any clear idea of what might be causing your problem,
or those who did missed it.
73, Ron AC7AC
-Original Message-
Oh well, so much for help
--
View this message in context:
ht
Oh well, so much for help
--
View this message in context:
http://elecraft.365791.n2.nabble.com/KX1-ATU-low-power-tp7558478p7558720.html
Sent from the Elecraft mailing list archive at Nabble.com.
__
Elecraft mailing list
Home: http://mai
Just finished the ATU module for the KX1. Relays all work and swr into the
DL1 is r 1.0 on all bands. Power output though is limited to about 2 watts
per the display. Minus the the ATU, the W1 says I am getting 3 watts into
the DL1 on all bands except 80M where it is 4 watts. Regulated bench
Frank,
Yes, I have several ideas:
Check it first on a 50 ohm dummy load to see if the power output as measured
with your 'scope (or RF Probe) agrees with that displayed by the KX1.
Your antenna is connected to the output of the tuner, and the displayed SWR
is read at the input of the tuner. Wha
Hi all,
Does anyone have any idea about the possible cause of the low power
reading by the KX1 ATU?
Thanks,
Frank
Hi,
After having been off the air for about a year (moving house; other
interests) I have recently fired up my KX1 again. When tuning up a
random length of wire, I noticed that
Hi,
After having been off the air for about a year (moving house; other
interests) I have recently fired up my KX1 again. When tuning up a
random length of wire, I noticed that the output power indicated by the
KX1 ATU was only 0.4 to 0.5 Watts (while SWR was good: 1:1.0 to 1:1.1).
I attached
8 matches
Mail list logo