On 5/20/2021 2:50 PM, Andy Durbin wrote:
"I can hear a 6 meter beacon on Data mode, but when I switch to CW I get no copy at
all."
Does the K3, like the TS-590, have a user option that defines how the change to
CW is handled?
Not that I know of. In digital and SSB modes, the dial frequency
I just dialed up a local beacon. With it producing about a 1 kHz tone in
the tx data mode, I switched the mode on my k3 to CW. the tone dropped
down by 600 hz, which is the CW offset/sidetone point I have in my K3.
If you hear it on the tx data mode, and you move to CW, adjust the vfo
+/-
Different side bands?
> On May 20, 2021, at 4:52 PM, John Stengrevics
> wrote:
>
> I have an unusual phenomenon. I can hear a 6 meter beacon on Data mode, but
> when I switch to CW I get no copy at all. Any thoughts?
>
> 73,
>
> John
> WA1EAZ
>
Unfortunately not that simple Andy. When switching to CW mode, I tune around
to make sure that it’s not a shift causing this . But , no luck.
John
WA1EAZ
> On May 20, 2021, at 5:50 PM, Andy Durbin wrote:
>
> "I can hear a 6 meter beacon on Data mode, but when I switch to CW I get no
> copy
"I can hear a 6 meter beacon on Data mode, but when I switch to CW I get no
copy at all."
Does the K3, like the TS-590, have a user option that defines how the change to
CW is handled? The options are typically to keep the dial frequency the same
and shift where the RX is listening, or to
I have an unusual phenomenon. I can hear a 6 meter beacon on Data mode, but
when I switch to CW I get no copy at all. Any thoughts?
73,
John
WA1EAZ
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:
6 matches
Mail list logo