On Fri, 8 Dec 2006 04:03:03 -0500 (EST) [EMAIL PROTECTED] wrote: > If only the firmware could determine when it was connected to > the KPA-100/KAT-100 or not and return control to the KAT-2. > (Sorry Wayne <g>.)
It kind of does. Upon detection of a KAT2 (in K2 enclosure), and KPA100/KAT100 (in EC2 enclosure), the firmware will switch the KAT2 in through mode (CALP), antenna port 1. Any tuning / antenna port selection will only drive the KAT100. Switch off the K2, disconnect, and your KAT2 will function as it used to. There's several minor glitches, though: - The 2nd port of the KAT2 is no longer accessible. It would be nice to switch between ANT1 (KPA100/KAT100), ANT2 (KPA100/KAT100), and ANT3 (KAT2, port 2), so that the latter can be used for a transverter - Under some circumstances, the KAT2 remains stuck in CALP mode when the KAT100/KPA100 is disconnected. It is easy to set it back to AUTO mode, you just have to remember. Geert Jan _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com