Hello:
I am in the midst of building the rf board for the K1. All went well until
page 30 in the manual.
I performed the voltage checks and the only one that works is the one at p1 pin
15. The others read zero on my DMM. I rechecked all soldering - no solder
bridges or cold joints. I
Ed,
I am not certain how you have 5.8-6.2 volts at P1 pin 15 and zero volts
at P1 pin 16.
The number of components you have installed at this point is not large,
so I suggest you trace the voltage from the input. Check the following
points in order (stop when you find one that is
elecraft k1 voltage checks
Ed,
I am not certain how you have 5.8-6.2 volts at P1 pin 15 and zero volts
at P1 pin 16.
The number of components you have installed at this point is not large,
so I suggest you trace the voltage from the input. Check the following
points in order (stop when
voltage for pin 16. All
others in the chart are at .1 V.
Date: Sat, 6 Jun 2009 21:24:44 -0400
From: w3...@embarqmail.com
To: doublehelix...@hotmail.com
CC: elecraft@mailman.qth.net
Subject: Re: [Elecraft] troubleshooting elecraft k1 voltage checks
Ed,
I am not certain
: elecraft@mailman.qth.net
Subject: Re: [Elecraft] troubleshooting elecraft k1 voltage checks
Ed,
Go through the checks that I have indicated anyway and let us know how
far down the list you get without the voltage going to zero. When you
have found where it goes to zero
5 matches
Mail list logo
