Julius, Check the thermistor board VERY carefully for solder bridges. As a quick sanity check on the health of the thermistor board, measure the voltage at RF board U6 pin 4 - if is not close to 4 volts, you can be certian there is a thermistor board problem. Note: that does not fully check out the thermistor board, but it is only a quick first check.
You can usually examine the back of the Thermistor Board by removing the Control Board and Front panel. 73, Don W3FPR > -----Original Message----- > > Have made it to the first Alignment on the K2 and am > not getting the appropriate 12.096 +/- reading. What I > am seeing is a reading in the 7 to 8 Mhz range > drifting up and down. > > L31, as provided with my kit, is marked 10uH. I've > gone over the soldering and components several times > (which means I've probably missed something obvious). > > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com