Dan, Yes, the Elecraft MH2 and the MD2 are no longer available. There have been some comments from Eric that they were persuing replacements, but no time frame for availablity was mentioned.
I will not make a specific recommendation, but I can give you some 'food for thought' One alternative is to use the Kenwood mic configuration, it is very close to the Elecraft mic configuaration (only a couple pins different and no resistor on the mic jack). Icom mics seem to be quite usable and the mic configuration info is in the KSB2 manual - most do need a resistor from the 5 volt pin to the AF pin at the mic jack (although some do not). I sent a post on mic considerations to the reflector yesterday - the subject line was 'Getting Started on K2', so you may want to review the archives for that additional info. 73, Don W3FPR > -----Original Message----- > > I am at the stage in my k2 building experience where I need to > configure the > mic jack in the rig. I want to keep the rig all Elecraft but > unless I read > the web site wrong, Elecraft no longer offer the one listed in > the accessory > page of the building manual. Does anyone have any suggestions or > experience with > the other mics they show that can be configured for use? > > Any input will be greatly appreciated. > > Dan af4lb (previously kf4pob) > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com