Fern, * AUTOINF ("Auto Info") menu entry added. (CONFIG menu; TECH MD must be ON.) This can be used to send band and frequency data to an attached device such as an antenna controller via the K3's serial port. The default is NOR, which doesn't send anything. If you set it to AUTO 1, any change in the K3's VFO frequency or band will send an "IF" (info) response at the K3's present RS232 baud rate. The commands are sent no more than once per second. PC software applications can always override the K3's power-up Auto-Info mode. NOTE: Some PC software may be incompatible with the AUTO 1 setting of AUTOINF because they already control the autoinfo mode.
73 Greg AB7R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Fern Rivard Sent: Sunday, March 23, 2008 5:56 PM To: Elecraft Reflector Subject: [Elecraft] re setting of Auto Inf menu Could someone please help with setting in the conf menu with Auto Inf which has choice of Nor or Auto 1. What do either choices do and what is the better setting? Thanks from Fern _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com