This is more-or-less possible with various packages, I would be able to
support this myself.
The only transverters I would use based on (1st) quality and (2nd) price are
Elecraft, unfortunately I can't find any info on the 430 MHz transverter
which was proposed a year or so ago. The quality
Ray,
You may have a situation with a PLL range that is a bit on the narrow side.
You could try shifting the entire VCO range (adjust L30 while observing the
voltage on R30) to see if you can get the 160 meter band within range too -
I would try that first.
If the above fails, you can adjust the
Hello Alan,
... After building virtually all of the Elecraft product line
=
I may have an answer that will make the step much easier.
Sorry, but try to build also some kits in practice. I have enough from
theoretician who know all and can less.
Hello to all
Hi! All
I'm finishing my K2 and I did the resistance checks. I have 2.27K ohms
result on the Q7 base instead of 2.5K-3.0K ohms. Because of the minim
difference I run the k2 with this failded test and I have 520 ma
reading.
Any one have an Idea?
Thanks
Sylvain VE2SSL
I have progressed to page 46 when I go to the PA menu parameter, I see Off,
on, F1.10 E, but never see the Fan nor.
Does anyone have an idea what I am doing wrong or do I have a hardware problem?
Bob
WB8DDI
K2 #4998
___
Elecraft mailing list
Post
Found my probelm...can't follow directions!
- Original Message -
From: Bob Wehking [EMAIL PROTECTED]
To: Elecraft@mailman.qth.net
Sent: Tuesday, September 20, 2005 1:40 PM
Subject: [Elecraft] KPA100 Fan Issue
I have progressed to page 46 when I go to the PA menu parameter, I see
Hello Ingo,
Alan has built over a hundred K2 kits. He has more practical experience than
almost anyone on this reflector. It's very nice of him to offer to help
others.
The way he used the phrase virtually all, it means almost all or
practically all.
It is not related to virtual reality.
73/
Bob,
To answer your power output discrepancy question first - the wattmeter in
the KPA100 must be properly calibrated before it will read correctly. If
you can trust the calibration of your LDG, you can set the KPA100 wattmeter
to match that reading. The instructions are in the manual.
BUT,
8 matches
Mail list logo