From: Jim Leder
Sent: Monday, May 25, 2015 2:00 PM
To: km...@km6cq.com ; Elecraft
Subject: [Elecraft] Cooler KX Plus Heatsink Install
I had the exact same experience with the longer screw being slightly off
center. And, since I did not do the build on mine, I was unaware of the sticky
Today I set about to get my new sound card/K3/LP-Pan 2/NAp3/new shack
computer working in harmony. Alas, it was not to be.
I've got the levels set correctly (thanks to Larry) and signals are apparent
on the band. What is perplexing is what I have named The Blob (see attached
screen shot). It
There is a cable from KPA100 called KPA100-J4 that normally connects to the
K2's P3 connector halfway along the right edge of the K2's RF board (when
looking from the front of the radio.
In a twins configuration, my guess is that this cable would not be connected,
in which case you would need
How does the K2 get it's power when only the high current supply is connected?
I ask because sometimes my K2 doesn't - unless I connect a supply to the K2
directly. Is it through the KIO2?
I also notice that when the power is lower the 11 watts, the SWR lights on my
KAT100 do not light - but
Folks,
I have a K2 that's a couple years old. A friend and I were working with it
a couple weeks ago and switched an antenna connection -- the K2 went blank.
After a bit of trancing it was apparent that one of the finals went. It was
not in transmit. Pulling the bad final resulted in the K2
Clark, set the audio driver to ASIO.
Tony KT0NY
On May 25, 2015 3:54 PM, engineercm clark.macau...@gmail.com wrote:
Today I set about to get my new sound card/K3/LP-Pan 2/NAp3/new shack
computer working in harmony. Alas, it was not to be.
I've got the levels set correctly (thanks to Larry)
I have been watching some youtube clips showing how by adjusting the phase and
amplitude of two received signals on a diversity receiver local noise can be
reduced by more than 20db.
This would be particularly useful to me as I have the dirtiest plasma TV on one
side of me and a gaggle of
For those of you running a K3 + RemoteRig station with multiple users, this
may be of interest. Although we could not get the K3 Utility to communicate
with the tower site K3 using RemoteRig's spare COM port, another list member
suggested Win4K3 Suite software. I can report that the software
Check the bias voltage. If it's too high, it can blow the finals. Sometimes
the circuit that provides the bias can have a shorted transistor and drive
too much current into the base of the final transistors.
Jack WA9FVF
Willco Electronics
-
Jack WA9FVP
Sent from my TRS-80 :-)
--
View
9 matches
Mail list logo